Porsche Macan Wheel Speed Sensor Replacement

  • Project Time: 1 hour
  • Tab: $4 to $160
  • Talent
  • Tools: 5mm Allen
  • Parts Required: Sensors, plastic grease
  • Performance Gain: Working ABS system
  • Complementary Modification: Brake bleeding

The Porsche Macan has had problems with the wheel speed sensors so much so that they have extended the warranty on them.

If your sensors are failing and you are out of the extended warranty don't worry, they are easy to replace.

One of the reason they would fail is because of water intrusion into the area where they are mounted. You want to get a little grease that is developed and safe to use on plastic. This will help seal the area.

Hot tip

Don't over torque the sensor

Steve Vernon, DIY Expert

//

Project Photos

Figure 1 Begin by safely lifting and supporting your Macan. If you have a steel suspension it is pretty straight forward. If you have PASM, air suspension or a GTS there are some special things you need to do to safely raise and support it. Please see our article and video on how to safely raise and support your Macan for additional assistant.
Figure 2 The rear wheel sensors are located on the rear of the hub (red arrow). There is one for each wheel. We are demonstrating on the left but the right is similar.
Figure 3 Begin by disconnecting the electrical connection. Insert your screwdriver into the tab and slightly lift it. This will release the tab and allow you to separate the connection.
Figure 4 Use a 5mm Allen and remove the single bolt holding the sensor to the hub (red arrow).
Figure 5 Pull the sensor out from the hub. Place a little plastic safe grease on the new sensor before inserting (red arrow). This will help seal up the area and prevent water from entering.
Figure 6 The front sensors are located on the front of the hub (red arrow). Use a 5mm Allen and remove the single screw holding the sensor in place and pull the sensor form the hub.
Figure 7 I found it easier to remove the sensor and wiring connection together as the dust shield makes it a tight fit. Insert your screwdriver into the tab and slightly lift it. This will release the tab and allow you to separate the connection (red arrow).

Figure 8 Place a little plastic safe grease on the new sensor before inserting (red arrow). This will help seal up the area and prevent water from entering. Installation is the reverse of removal.







Comments and Suggestions

Teddy Edwards

October 24, 2024

Can you replace just one speed sensor?

Followup from the Pelican Staff:

Yes. With your vehicle info handy, give The Pelican Parts parts specialists a call at 1-888-280-7799. They can figure out what part or repair kit you need. - Nick at Pelican Parts

Add a New Comment
Upload a Photo:

Got more questions? Ask any of our automotive experts.