Porsche Macan Front Window Switch Replacement

  • Parts Required: New Switch
  • Performance Gain: Working windows
  • Complementary Modification: Check all switches functionality

To replace the front window switches you will need to remove the door panel first.

Please see our article and video on Door Panel Removal for additional assistance.

Hot tip

Do not try and pry it out from above without removing the panel

Steve Vernon, DIY Expert

//

Project Photos

Figure 1 To replace the front window switches you will need to remove the door panel first. Please see our article and video on door panel removal for additional assistance. Some people will insist that you can replace the switch without removing the panel but there is very little room to work and a very good chance you are going to damage the panel. Be smart and do it the right way.
Figure 2 You are going to remove the door panel arm rest. Place the panel face down on a soft, clean surface. Gently release the insulation from the retaining hooks (red arrows).
Figure 3 Use a T20 Torx and remove the 6 screws holding the front of the arm rest from the panel (red arrows).
Figure 4 Working on the rear of the arm rest disconnect the ambient light wiring connection (red arrow).
Figure 5 Then use a T20 Torx and remove the remaining 8 screws (red arrows).
Figure 6 Holding the arm rest in place so as to not damage the panel flip the panel over and remove the handle. If it has not been removed before you will have to give it a gently tug.
Figure 7 You cannot remove the electrical connection until you release the switch from the handle. There are four clips that hold the switch in place. The two on the outside of the handle are easy to get to (red arrows). The two on the other side will require a bit of patience.
Figure 8 Once you compress the outer two you can move the switch slightly upwards to get access to the other two clips. Once they are free you can slide the switch out from the handle.
Figure 9 With the switch free release the tab on the electrical connection (red arrow) and separate it from the switch.
Figure 10 Installation is the reverse of removal. Remember to run the electrical connection up through the handle and reconnect it before clipping the new switch into place. To teach the end positions. Reinstall door panel and start vehicle. Pull the rocker switch until the window is fully closed. Pull the switch again and the upper position is stored. Press the rocker switch down until the window is fully opened. Press the switch down again.


Comments and Suggestions

Add a New Comment
Upload a Photo:

Got more questions? Ask any of our automotive experts.