Porsche Macan Front Window Motor Replacement

  • Project Time: 1hr
  • Tab: $
  • Talent
  • Tools: T20 Torx, pick
  • Parts Required: Window motor
  • Performance Gain: Working windows
  • Complementary Modification: Clean the window glass

When working around the front door window motor make sure it cannot be operated while working, and place the remote key far enough away so the car cannot be powered.

Hot tip

Make sure there is no power to the door

Steve Vernon, DIY Expert

//

Project Photos

Figure 1 When working around the door window motor make sure it cannot be operated while working. Place the remote key far enough away so the car cannot be powered.
Figure 2 You will need to remove the front door panel to access the motor. Please see our article and video on front door panel removal for additional assistance.
Figure 3 You will need to remove the window motor from the regulator (red arrow).
Figure 4 Slide out the locking tab (red arrow) and the press down on the small tab (green arrow) and separate the wiring connection
Figure 5 Use a T20 Torx and remove the three screws holding the motor to the regulator and door frame (red arrows).
Figure 6 Pull the motor off of the three plastic pegs that it connects to on the regulator (red arrows).
Figure 7 When reinstalling the geared teeth on the motor must sit in the splines on the regulator.
Figure 8 This image shows the gear teeth that must sit flush within the regulator. You may have to move the window a little up or down to get the motor to fit correctly. Installation is the reverse of removal. Torque to 3.3 Nm or 2 ftlb. To teach the end positions. Reinstall door panel and start vehicle. Pull the rocker switch until the window is fully closed. Pull the switch again and the upper position is stored. Press the rocker switch down until the window is fully opened. Press the switch down again.

Comments and Suggestions

Add a New Comment
Upload a Photo:

Got more questions? Ask any of our automotive experts.