Porsche 986 Boxster Top Engine Access

  • Project Time: 10 minutes
  • Tab: Free
  • Talent
  • Tools:
  • Parts Required:
  • Performance Gain:
  • Complementary Modification:

Because the Porsche Boxster utilizes a mid-engine layout, the engine is positioned between the passenger compartment and the rear trunk.

To service common components such as the air filter, intake system, or perform light top-side maintenance, Porsche designed a convenient top engine access panel located behind the seats and beneath the convertible top clamshell. Removing the top engine access cover requires no tools and only a few minutes. In this article, we will walk through the correct procedure to access the upper portion of the engine to make life easier during routine service.





Hot tip

An extra set of hands when removing the engine cover can help prevent damage to your decklid

Damien Harshbarger, DIY Expert

//

Project Photos

Figure 1 Begin by partially opening the convertible top. This will lift the rear clamshell enough to provide access to the carpeted engine access area behind the seats. Do not fully retract the top--only open it until the clamshell is at its top limit position.
Figure 2 With the top partially open, locate the support cables on each side of the convertible top assembly. Each cable uses a ball-and-socket connection. Pull firmly outward to detach each cable. Repeat for both sides.
Figure 3 Release the fabric cover by pushing the plastic channel downward and out of the two locking tabs. Once the support cables and fabric cover are out of the way, lift the rear portion of the convertible top upward until it stays in place. This will expose the upper carpeted cubby section located above the engine cover.
Figure 4 The upper cubby is secured by two quarter-turn fasteners. Lift each tab and rotate to release them. Lift the cubby straight up and remove it from the vehicle.
Figure 5 Below the cubby is a second carpeted panel secured with quarter-turn fasteners. Release each fastener and lift the panel upward and out of the vehicle.
Figure 6 The engine access cover is held in place by a third set of lock fasteners. Lift each fastener tab and rotate until all tension is released. Once free, lift the engine access cover out of the vehicle.
With the engine access cover removed, you now have full access to the top of the engine, including the air filter housing, intake components, power steering fluid reservoir, and other service points. This makes routine maintenance significantly easier.

Comments and Suggestions

Jack

October 4, 2026

Thank you but photos too dark to be helpful to the 'novice'

Followup from the Pelican Staff:

Thanks for the feedback. We appreciate it. I will ask to have the photos updated. - Nick at Pelican Parts

Add a New Comment
Upload a Photo:

Got more questions? Ask any of our automotive experts.