Pelican Parts
Parts Catalog Accessories Catalog How To Articles Pelican Tech Forums
Call Pelican Parts at 888-280-7799
- Back to Catalog -
911 Engine/Transmission Jack Adapter
911 Engine/Transmission Jack Adapter (1984-98)
911 Engine Only Jack Adapter
Porsche 911 Engine Lift Bar Tool
Jack Pad
Jack Stands
AC Hydraulic Jacks
Lug Nut Soft Socket
Lug Nut Torque Socket Set
Porsche Engine Rebuild Stand
Engine Stand for Water-Cooled Engines
Engine Stand Adapter Ring
Engine Yoke Securing Nuts
12-Point/12mm Flywheel Socket
Heavy Duty Flywheel Lock
Oil Filter Wrenches
Drain Plug Removal Tool
Transmission Drain Plug Removal Tool
Smart Racing Products Alignment Tools
Hub/Bearing Extractor and Installer Kit
Oil Seal Installation Tools
Secondary Air Injection (SAI) Maintenance DVD
Secondary Air Injection (SAI) Maintenance Tool Kit
Mechanical Tensioner/Tool
Cylinder Holding Tool
Top Dead Center Indicator
Leakdown/Compression Gauge Adapter
Metric Dial Indicator Gauge
Cam Nut Tool
Camshaft Tools
Camshaft Sprocket Alignment Tool
Valve Spring Tools
911 Valve Adjustment Tool
Valve Adjustment Tool with Loop Handle
Exhaust Head Stud Repair Kit
Crankshaft Holder
Circlip Injector Tool
Transmission Synchro Tools
Shift Fork Jig
Pulley Wrench Tools
Fuel Injection Tools
Mechanical Injection Pump Tools
CIS Fuel Enrichment Wrench
C.I.S. K-Jetronic Fuel Injection Tester
Ball Joint Tools
Tie Rod Tools
Factory Timing Belt Tensioning Tool
Timing Sprocket Registration Pin Puller
944/968 Flywheel Lock
Float Gauge
Allen Head Tools
CV Bolt Removal Tool
Magnetic Box "V" Wrench (17mm)
Suspension Alignment Tools
Ride Height Wrench
Trailing Arm Height Adjuster
Elephant Racing Spring Plate Bushing Removal Tool
Extraction Tools
Spanner Wrench Set
32 MM Oil Line Wrench
36 MM Oil Line Wrench
Clutch Alignment Tool
Disassembly Tools
Factory Air Pump
Custom Service Cover
Durametric Software Diagnostic Tool for Porsche
AutoEnginuity Complete OBDII Diagnostic Tool
ScanTool Software Expansions
Air/Fuel Ratio Meter
WEGO IV Wide-Band Air/Fuel Ratio Tuning Aid
Innovate Motorsports LM-2
Redline Detection Smoke Pro
Airlift Cooling System Tool Kit
Radio Removal Tools
Pelican Engine Rebuild Super Tool Kits
- Back to Catalog -
Home >  Porsche Catalog >   Porsche Tools  
Porsche Tools - Page 4

Hub/Bearing Extractor and Installer Kit   Camera Pic

Want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one Porsche kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze.

The kit comes with a set of adapters specific to the Porsche series, but can also be used on all front and rear wheel drive vehicles with independent suspension. Also for R&R of the rear wheel bearings only on models with drum brakes independent rear suspension.


Hub/Bearing Extractor and Installer Kit, 911 1965-73, 912 All, 914 All    [More Info]



Rear Hub/Bearing Extractor and Installer Kit, 911 1973-on, 924, 944, 968, All, Boxster    [More Info]


Hub/Bearing Extractor and Installer Kit, 911 Turbo (1990-), 928 All    [More Info]


Oil Seal Installation Tools

When rebuilding your motor, do the job right with our oil seal installation tools. Designed to perform an installation that is perfectly aligned with the case, these installation tools will guarantee a leak-free seal, without damaging your valuable case.


Oil Seal Installation Tool for 911 (1965-77), Flywheel Side    [More Info]



Oil Seal Installation Tool for 911 (1978-94), Flywheel Side    [More Info]



Oil Seal Installation Tool for 911 (1965-89), Pulley Side    [More Info]



Oil Seal Installation Tool (for original-style seal) - Flywheel Side, 996 Carrera 2/4 (1999-04), Boxster/Boxster S (1997-04), Each     [More Info]



Oil Seal Installation Tool - Pulley Side, 996 Carrera 2/4 (1999-04), Boxster/Boxster S (1997-04), Each     [More Info]



Oil Seal Installation Tool for 944, Balance Shaft    [More Info]



Oil Seal Alignment Tool for 944 (1983-86)    [More Info]


Secondary Air Injection (SAI) Maintenance DVD

The SAI system consists of an electric air pump, a check valve and a series of tubing and ports that direct fresh air directly aft of the exhaust valves for about 2 minutes during engine cold start. Often times, the Check-Engine-Light (CEL) will illuminate because the SAI ports in the cylinder heads have become clogged with carbon soot and fresh air is no longer able to reach the exhaust system. The overly "rich" emission is sensed by the (4) oxygen sensors and a fault is recorded and your 993 will not pass emissions testing. To unclog these SAI ports runs into the thousands of dollars to have your local dealer perform the maintenance!

Yellow Cap Garage has created a new brand of repair DVD. A Red Cap Garage DVD is where YCG goes into other expert's garages and film them doing the work. This SAI DVD features Robin Sun & Chris Walrod of fame! All sequences shown in this DVD are completed on an actual car & not on a bench or engine stand.

This DVD will step you through the following sequences:
Tools required to do SAI maintenance & where to buy specialty tools
Parts required to do SAI maintenance with actual Porsche part numbers
Safety tips & helpful hints on how to lift a 993
How to remove the airbox & mass air sensor to access SAI valve
How to remove SAI valve with specialty tools
How to remove heat exchangers to gain access to SAI ports
How to apply de-carbonizer/pressurized air to unclog (6) SAI ports
How to install new SAI valve
How to reassemble airbox/mass airflow sensor/heat exchangers
Closing tips to assure the job is right & complete
Running time: 1.1 hours


DVD, Secondary Air Injection (SAI) Maintenance for the 993 (1994-98)    [More Info]

Secondary Air Injection (SAI) Maintenance Tool Kit
The Secondary Air Injection (SAI) kit includes all the specialty tools required to do the SAI maintenance on your 993. The kit includes the following:
27 mm crowfoot for removing & installing the SAI valve
SAI valve adapter (allows de-carbonizer & air pressure to be injected into the 6 SAI ports)
Air hose adapter w/on-off valve which connects to the SAI valve adapter & air compressor


Secondary Air Injection (SAI) Maintenance Tool Kit    [More Info]


Mechanical Tensioner/Tool   Camera Pic

Use these specially designed and fabricated mechanical tensioners to set cam timing (they don't interfere as normal tensioners do), or as a bulletproof alternative to pressure-fed or hydraulic tensioners for racing. CNC machined from 6061 aluminum and anodized for years of service, these will become an integral part of your tool box or race motor. Complete with tensioning bolts, locking nuts, and spacers.


Stomski Racing Mechanical Chain Tensioning Tool Set (pair), 911 (1965-98)     [More Info]


Cylinder Holding Tool


Porsche 911 Cylinder Holding Tool (sold per each, 6 required), 911 (1965-98)    [More Info]

No Longer Available 


Stomski Racing Cylinder Hold-down Nut Set (six included), 911 (1965-98)     [More Info]


  Page 4 of 13  <12345678910111213>


About Us
Pelican Parts, LLC
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
Sign Up for Pelican Pit Stop News & Special Offers
Copyright 2016 Pelican Parts, LLC
DMCA Registered Agent Contact Page

Page last updated: Mon 3/19/2018 01:15:07 AM