Pelican Parts
Parts Catalog Accessories Catalog How To Articles Pelican Tech Forums
Call Pelican Parts at 888-280-7799
- Back to Catalog -
Pelican Parts Tool Catalog
BMW Code Scan / Reset Tools
BMW SRS Reset Tool
Oxygen Sensor Removal Tools
Lug Nut Soft Socket
Lug Nut Torque Socket Set
BMW Oil Filter Socket
BMW Suspension Tools
Rear Wheel Bearing Extractor and Installer Kit
B90 Adapters
Front Wheel Hub/Bearing Nut Socket
Rear Subframe Bushing Master Kit
Front Control Arm Bushing Master Kit
Press Arbor Kit/Outer Ball Joints
Press Arbor Kit/Inner Ball Joints
Heavy Duty Separator
Pin Wrench Socket
Coil Spring Compressor
Engine Tools
Tensioner Pressure Tool
Camshaft Alignment Tools
Timing Tensioner Bracket
Camshaft Holding Tool
Flywheel Lock
Camshaft Holding Tools
Cam Sprocket Turning Spanner
Crank Pulley Securing Tools
Harmonic Balancer Service Master Kit, for BMW M52TU, M54, M56
Steering Rack Pin Wrenches
Universal Oil Seal Extractors
Oil Seal Arbors
Engine Turning Bars
Timing Chain Crimping Tools
Valve Adjusters
E30 M3 Valve Adjustment Tool Set
E46 M3 Valve Adjustment Tools
E46 M3 Valve Adjustment Shim Kit
Head Bolt Torx Socket Tool
Torque Angle Meter
Tappet Depressors
Transmission Tools
Transmission Bearing Extractors
30mm Flange Nut Socket
Drain Plug Socket Set
Transmission Drain Plug Socket
Differential Mount Bushing Kit
Transmission/Differential Oil Seal Arbors
Clutch Tools
Torx Female Socket Set
Clutch Wear Gauge
Pilot Bearing Puller
Clutch Disc Alignment Tools
Install Tool for Self Adjusting Clutches
Mityvac Brake Bleeder Kit
Brake Fluid Tester
Power Bleeders
Pressure Adapter
Disassembly Tools
Cooling System Tools
Fan Clutch Wrench
Cooling System Pressure Tester
Counter Holder/Fan Removal Tools
Fuel Level Sending Unit Socket
Brake Caliper Piston Tool
AutoEnginuity Complete OBDII Diagnostic Tool
ScanTool Software Expansions
Air/Fuel Ratio Meter
WEGO IV Wide-Band Air/Fuel Ratio Tuning Aid
Innovate Motorsports LM-2
Redline Detection Smoke Pro
Airlift Cooling System Tool Kit
Jack Stands
AC Hydraulic Jacks
Radio/Navigation Removal Kit
- Back to Catalog -
Home >  BMW Catalog >   BMW Parts - Tools  
BMW Parts - Tools - Page 7

Transmission Tools

30mm Flange Nut Socket
This special 30mm deep walled socket is used to remove both the drive shaft flange nuts and the pinion drive shaft nuts on the differential.


30mm Flange Nut Socket, BMW All Models     [More Info]

Drain Plug Socket Set


Drain Plug Socket Set of 3, Single Piece Construction, Universal for most BMW applications (Includes 10mm, 14mm, 17mm), Set Note: Please verify size before ordering.    [More Info]

Transmission Drain Plug Socket
This special 17mm ID socket is used to remove the transmission fill and drain plugs. This tool is essential when doing any transmission service.

Please be sure to check first if your transmission uses this type and size of plug before ordering.


Transmission Drain Plug Socket, BMW Models with 17mm allen plugs ONLY     [More Info]

Differential Mount Bushing Kit


Differential Mount Bushing Kit, Front, Needed for servicing front differential mount bushings in rear subframe (Bushing #33-17-6-770-788-M69), E46 3-series (Except M3) BMW Service Tool Reference #33-3-360     [More Info]



Differential Mount Bushing Kit, Rear, Needed for servicing rear transverse differential mount bushings in rear subframe (Bushing #33-17-6-751-808), E46 3-series (Except M3), BMW Service Tool Reference #33-3-370    [More Info]

Transmission/Differential Oil Seal Arbors
These oil seal arbors are used to properly install the oil seals on the transmission and differential output shafts.


Transmission Oil Seal Arbor For Getrag Transmissions, Check Plate on Transmission for Model Number, All Getrag G242/262/G240 and 260 transmissions    [More Info]

No Longer Available 


Differential Oil Seal Arbor, BMW All E23, E24, E28, E30 E32 And E34 Models     [More Info]

No Longer Available 

Clutch Tools

You can never perform a good job on repairing your BMW if you don't have the right tool. A lot of people try to cut corners because they either don't have the tool they need, or they don't even know that it exists! Having the right tool for the job saves time, money, and wasted effort. A job that can take 4 hours without the right tool, can take a mere few minutes. You're already saving lots of money by doing the work yourself, spend some money and get the tool that you need. Once it's in your collection, you will not know how you got along without it!
Torx Female Socket Set
These odd-shaped sockets are required to remove some of the bolts that connect the engine to the transmission. Seven sizes E-6 through E-16. The three smaller sizes are 1/4" drive; the four larger sizes are 3/8" drive. Made of heat-treated alloy steel. Sockets are kept in a convenient vinyl holder. Includes External Torx Sockets: E6, E7, E8, E10, E12, E14, and E16.

Torx Female Socket Set    [More Info]

Clutch Wear Gauge
This tool allows you to check the thickness of the clutch disc without having to remove the transmission (BMW Service Tool# 21 2 060). Information on how to use the tool is located on page 3 of this BMW factory manual.


Clutch Wear Gauge, Fits M10, M20, M30, S14 S38 Engines ONLY     [More Info]

Pilot Bearing Puller
Designed to extract bearings and bushings with an I.D. of 12mm up to 15mm.

Pilot Bearing Puller, BMW All Models     [More Info]

No Longer Available 

  Page 7 of 12  <123456789101112>


About Us
Pelican Parts, LLC
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
Sign Up for Pelican Pit Stop News & Special Offers
Copyright 2016 Pelican Parts, LLC
DMCA Registered Agent Contact Page

Page last updated: Mon 2/19/2018 12:06:07 AM