Are you having trouble removing the oxygen sensor? Many times, it is not possible to get a wrench or socket around the sensor due to its location in the exhaust. Once again, Pelican has your answer. This special tool allows you to remove the oxygen sensor using a standard 3/8" drive ratchet, simplifying an otherwise difficult job.
Designed for the proper removal and installation of the outer ball joints. Comes complete with all the components to perfectly mate up to the factory ball joints. Must be used in conjunction with a hydraulic press.
If you want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one master kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze. The tool eliminates the need for such drastic measures such as a slide hammer or flame torch to remove the rear wheel bearing. The tool facilitates the installation and removal of the rear bearings, and makes the whole job 1000% easier.
This site was designed and produced solely by Pelican Parts. Pelican Parts is not associated with Porsche Cars North America in any manner, except for a mutual appreciation and love of the cars. All pictures and references to the Porsche name, and the car names and shapes are for restoration reference only, and do not imply any association with Porsche. Pelican Parts is not responsible for any typographical errors contained within the site. Information and technical articles within this website are for reference only. Consult authorized factory manuals when performing repair procedures. By entering this site, you agree to hold Pelican Parts free from any liability arising out of the use of any information contained within.