Pelican Parts
BMW Parts Catalog Accessories Catalog BMW How To Articles BMW Tech Forums
Call Pelican Parts at 888-280-7799
1970 BMW 1602 Base Coupe
BMW Home > 1970 BMW 1602 Base Coupe > EngineCylinder Head & Valvetrain 

Cylinder Head & Valvetrain

- Page 1

Valve Cover Gaskets

These gaskets should be replaced every time that you adjust your valves. You should also put a little gasket sealer on the inside of the cover where the gasket mounts to the cover. This should prevent the oil leaks that sometimes occur when there isn't a really good seal.
Valve Cover Gasket

Valve Covers

Valve covers cover the valve train on the top of the heads. They are easily removed to allow servicing the valve train. Always install a new gasket after removing the cover.

Cylinder Head Gaskets

Here at Pelican we offer head gasket sets for your vehicles. Whenever you remove the head, always replace the head gasket and have the head surfaced to ensure proper sealing between the head and the engine block.
Cylinder Head Gasket Set

Intake / Exhaust Gaskets

In this section you will find the gaskets that seal the intake manifold to the cylinder head. Replace them whenever you remove any intake components. Good intake gaskets are crucial for proper running of your car. If you have leaks, it can cause the car to run improperly, and possibly cause engine damage. Also included are the gaskets that seal the exhaust manifolds to the cylinder head. Replace them whenever you remove any exhaust components. Keeping your exhaust components sealed is vital to keep your car running correctly.
Exhaust Seal Ring (47 mm)
Exhaust Seal Ring (47 mm)  
[ More Info ]

Note: Down Pipe to Center Muffler Steel Ring

Brand Rating

Valves and Guides

A critical part of any head rebuild is new OEM intake and exhaust valves. Many times valves can be reground and reused, however if your valves are too worn to be re-used, Pelican can supply you with the needed parts for your rebuild. Valve Guides act to provide valves with proper lubrication while your engine is running. Any head rebuild should include new Valve Guides. Whenever you replace the valve guides, be sure to check the size of the original valve guide before ordering.
Valve Guide - Intake/Exhaust 1st Replacement (14.05 X 8.00 mm)

Valve Guide - Intake/Exhaust 2nd Replacement (14.15 X 8.00 mm)

BMW Home  >  1970 BMW 1602 Base Coupe > Engine  >  Cylinder Head & Valvetrain 

  Page 1 of 3  123>

Browse Cylinder Head & Valvetrain for all 1600, 2002 (1967-1976) vehicles

Page last updated: Tue 1/16/2018 11:54:41 PM
About Us
Pelican Parts, LLC
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
Sign Up for Pelican Pit Stop News & Special Offers

Close this window