Momo part number MO-8010, fit perfectly on my 1988 924S. Kit includes adapter, horn wiring and rubber boot. It does not provide additional clearance from the turn signal, wiper controls compared to factory steering wheel so a wheel with 70-90 mm off-set is recommended. Installation/wiring instructions are not included. Also, turn signal cancellation spoke was the same length as factory wheel so it did not need to be ground down as some forums recommend. The Porsche factory washer under the wheel retention nut was sufficient no additional washer needed.
This site was designed and produced solely by Pelican Parts. Pelican Parts is not associated with Porsche Cars North America in any manner, except for a mutual appreciation and love of the cars. All pictures and references to the Porsche name, and the car names and shapes are for restoration reference only, and do not imply any association with Porsche. Pelican Parts is not responsible for any typographical errors contained within the site. Information and technical articles within this website are for reference only. Consult authorized factory manuals when performing repair procedures. By entering this site, you agree to hold Pelican Parts free from any liability arising out of the use of any information contained within.