Removing the Trunk Liner and Brake Booster Cover  | Remove the battery cover. This is so you can disconnect the power later when you splice into the power. |
 | Next you need to remove the brake booster cover. |
 | There's three screws along the edge you need to remove. (While you're at it, take a look at the anchors that these screws go into. Brilliant! There are blocks with several holes so you don't have to be exact in aligning them when you reassemble it. |
 | There's also a twist lock on the side. |
 | If you look carefully, you can see the small connector that supplies power to the trunk light on the left. Unplug it. |
 | The liner now comes off easily. There are a couple of plastic screw fittings, and a few smaller snaps that you just pull out. After removing the liner, don't forget to take off the spare tire mount, otherwise it will fall off. |
Now let's take a look at what you should have received with your parts kit.
Page 1 - Introduction: Starting off, removing old lights
Page 2 - Removing the Rear Components: CD changer, amp
Page 3 - Removing the Trunk Liner
Page 4 - Parts provided in the kit
Page 5 - Wiring it up
Page 6 - Finishing up
Page 7 - Adjusting the Mounting Plate: Not normally needed, but it may come in handy
Want to learn more about purchasing the Roof Transport System?
Check out our on-line catalog for more information!
|
Loading Customer Comments...
