Parts Catalog Accessories Catalog Tech Info Tech Forums
 
  Search our site:    
View Recent Cars  |   Cart  | Project List | Order Status | Help    
 >  >
Air Filter Housing Removal
 
Bookmark and Share

Pelican Technical Article:

Air Filter Housing Removal

Jared Fenton

Time:

2 hours2 hrs

Tab:

$0

Talent:

**

Tools:

10mm wrench

Applicable Models:

Porsche 955 Cayenne (2004-08)
Porsche 955 Cayenne GTS (2008)
Porsche 955 Cayenne S (2003-08)
Porsche 955 Cayenne Turbo (2003-08)
Porsche 955 Cayenne Turbo S (2006)

Parts Required:

Air filter housing, air filter

Hot Tip:

Clean the filter housing before re-installing.

Performance Gain:

Access to alternator, steering pump and other components
Removing the air filter housing is easy and gives you room to work on other components like alternator and power steering pump.
Left side of car - After removing the air filter cover, filter element and MAF sensor, lift the water line (green arrow) up and over the top of the air filter housing.
Figure 1

Left side of car: - After removing the air filter cover, filter element and MAF sensor, lift the water line (green arrow) up and over the top of the air filter housing.

Both sides of car: The filter housing is secured to the car with a single 10mm bolt (green arrow).
Figure 2

Both sides of car: The filter housing is secured to the car with a single 10mm bolt (green arrow). Remove the bolt and then go inside the wheel well of the car.

Both sides of car: This view shows the filter housing from inside the wheel well.
Figure 3

Both sides of car: This view shows the filter housing from inside the wheel well. You'll need to pull the intake hose (green arrow) off the snout at the front of the housing (yellow arrow).

Both sides of car: Shown here is a close-up of the intake hose connection.
Figure 4

Both sides of car: Shown here is a close-up of the intake hose connection. When re-installing the housing, make sure to pull the lip of the hose over the lip on the housing (green arrow) It might take a little bit of force to pull it on.

Both sides of car: Note the grommets at the bottom of the filter housing (green arrows).
Figure 5

Both sides of car: Note the grommets at the bottom of the filter housing (green arrows). Pull the housing up and out of the grommets on the chassis. When re-installing the housing, make sure the tabs fit into the grommets.

Both sides of car: Tilt the filter housing (green arrow) towards the engine to remove it from the car.
Figure 6

Both sides of car: Tilt the filter housing (green arrow) towards the engine to remove it from the car. Simply pull it up and out once free. Be sure to clean the insides of the housings with a rag before re-installing.

Shown here is the finished result, more access to the various engine components on the sides of the engine.
Figure 7

Shown here is the finished result, more access to the various engine components on the sides of the engine.

Bookmark and Share

  Search our site:    

View Cart & CheckOut | Project List | Order Status |  Help    

 

[Home] [Customer Service] [Shopping Cart] [Project/Wish List]
  [Privacy Statement]  [Contact Us] [About Us] [Shipping] [Careers]

Copyright © Pelican Parts Inc. -    DMCA Registered Agent Contact Page

Page last updated: Fri 12/9/2016 02:33:47 AM