| BMW 740i 740iL - Intake System - Page 1 |
| From the airbox to the intake manifold, air is routed to the engine at a defined volumetric rate that allows optimum combustion for specific levels of performance. Any alteration or failure within this system can therefore cause drivability problems like hesitation or rough idling. You can try cleaning and sealing these components as much as you want, but more often than not, installing brand new OEM parts is the best cure for these types of problems. |
|
Air Filter |
| It's important to make sure that your air cleaner is clean at all times. The cleaner filters outside air before it enters your engine. Dirty air filters will constrict the air flow, and reduce your overall horsepower and gas mileage. You should replace |
|
| Air Filter, 740i, iL (1 Per Car) |
13-72-1-736-675-M45 | Air Filter, 740i, iL (1 Per Car)
Brand: Hengst [Photo] |  |
| $14.25 |  |
13-72-1-736-675-M63 | Air Filter, 740i, iL (1 Per Car)
Brand: Mann [Photo] | |
| $11.25 | |
| 13-72-1-736-675-M67 | Air Filter, 740i, iL (1 Per Car)
Brand: Mahle Filter | |
| $11.00 | |
13-72-1-736-675-M318 | Air Filter, 740i, iL (1 Per Car)
Brand: K&N [Photo] | |
| $54.75 | |
Air Mass Sensor |
| This meter is part of the fuel injection system and is used to measure the amount of incoming air into the intake manifold. |
|
| 13-62-1-702-078-M14 | Air Mass Sensor, 740i, iL
Brand: Bosch | |
| $330.00 | |
Engine Air Intake Boot/Hose |
| The Intake Boot is used to connect the intake manifold to the air flow meter. |
|
13-71-1-747-995-M89 | Intake Boot Air Mass Sensor to Throttle Housing, 740i, iL
Brand: EZ [Photo] | |
| $70.50 | |
| Air Boot Rubber Ring |
|
| 13-71-1-702-002-M9 | Rubber Ring for Air Flow Sensor Boot at Secondary Throttle Body NOTE: Only for cars with ASC, 740i, iL
Brand: Genuine BMW | |
| $6.75 | |
13-71-1-736-195-M9 | Rubber Ring for Air Flow Sensor Boot at Air Flow Sensor, 740i, iL
Brand: Genuine BMW [Photo] | |
| $6.50 | |
13-71-1-747-985-M9 | Rubber Ring for Air Flow Sensor Boot at Throttle Body, 740i, iL
Brand: Genuine BMW [Photo] | |
| $7.75 | |
Intake Manifold Gasket |
| The intake manifold gaskets used to seal the intake manifold to the cylinder head. |
|
| 11-61-1-433-328-M17 | Intake Gasket 4 Per Car, 740i, iL
Brand: Victor Reinz | |
| $15.00 | |
11-61-1-729-728-M17 | Gasket for Rear Intake Manifold Cover, 740i, iL
Brand: Victor Reinz [Photo] | |
| $3.25 | |
Engine Intake Manifold Cover Cap |
11-61-1-747-085-M9 | Cover Cap NOTE: For intake manifold cover #11 61 7 501 562, 740i, iL
Brand: Genuine BMW [Photo] | |
| $5.00 | |
