| BMW 735i 735iL - Fuel Injection - Page 3 |
Accessories & Performance |
| Swepco 503 Fuel Improver |
| Restore lost power and clean your Fuel Injection or Carburetors. Removes impurities and particle build up. Drive your engine clean! |
|
SWE-503 | Swepco 503 Fuel Improver, 8oz [Photo] | $6.65 |  |
| Air/Fuel Ratio Monitors |
The K&N Air/Fuel Monitor is designed to help the performance enthusiast calibrate and fine tune the air/fuel mixture ratio. It is an invaluable diagnostic tool that has a place in everyone's tool box, or you can install it in your car to give you real-time readings. This kit continually monitors an engine's air/fuel ratio while the engine is running. It is extremely sensitive to air/fuel ratio changes and will show them instantly and accurately, within the range of the oxygen sensor.
The instrument works whether the engine is carbureted or fuel injected, normally aspirated, turbocharged, or supercharged, and at any load condition. This precision instrument also works with nitrous oxide, but will not work with diesel or nitromethane fuels. This kit comes complete with an oxygen sensor that must be installed into the exhaust system by welding. If your 911 is already equipped with an oxygen sensor (1980-89), an air/fuel monitor may be purchased separately and wired into the existing electrical system. An oxygen sensor is also available separately.
Vehicles with dual exhaust systems (like the 911) can utilize an oxygen sensor in each headpipe or collector that is controlled by a switch that will allow each sensor or bank of cylinders to be read independently. This can show if there is a fuel distribution problem within the intake system, or help to pinpoint a potential problem in advance. |
|
PEL-SW85-2437 | Rectangle Surface mount Air/Fuel Ratio Monitor Kit, w/oxygen sensor [Photo] | $199.55 | |
PEL-SW85-2441 | Round In Dash mount Air/Fuel Ratio Monitor Kit, w/oxygen sensor [Photo] | $256.95 | |
PEL-SW85-2439 | Rectangle Surface mount Air/Fuel Ratio Monitor Kit, without oxygen sensor [Photo] | $188.35 | |
PEL-SW85-2442 | Round In Dash mount Air/Fuel Ratio Monitor Kit, without oxygen sensor [Photo] | $217.40 | |
PEL-SW85-2438 | Replacement Oxygen Sensor [Photo] | $85.00 | |
PEL-SW85-2440 | O2 Sensor Plug and Fitting [Photo] | $21.60 | |
| PEL-SW85-21688 | Weld on Fitting | $14.50 | |
| PEL-SW85-21686 | O2 Sensor Plug | $16.15 | |
Tools |
| You can never perform a good job on repairing your Porsche if you don't have the right tool. A lot of people try to cut corners because they either don't have the tool they need, or they don't even know that it exists! Having the right tool for the job saves time, money, and wasted effort. A job that can take 4 hours without the right tool, can take a mere few minutes. You're already saving lots of money by doing the work yourself, spend some money and get the tool that you need. Once it's in your collection, you will not know how you got along without it! |
|
| Bosch CIS Tester |
| Use the same equipment that the factory techs use to dial in the fuel injection system. Comes complete with all the fittings, schematics and detailed instructions. For Bosch K-Jetronic CIS Systems only. |
|
PEL-PP910450 | Bosch CIS Tester [Photo] | $218.95 | |
| Digital Air/Fuel Ratio Meter |
Tuning an engine for maximum power previously required long trial-and-error sessions on a dynamometer. With the LM-1, precise AFR measurement allows the user to correctly adjust many variables- including carburetor jetting, fuel injection, turbo fuel curves, etc.- without long and expensive dyno sessions. The meters digital signal processing technology provides data on exactly how rich or lean an engine is running at any load. The LM-1s self-calibrating circuitry also compensates for changes in temperature, altitude, and sensor condition.
The instrument can sample and store the air-fuel-ratio and the other sensor data internally in operation for later analysis on a personal computer. At a sampling rate of 12 samples/second the instrument can store up to 44 minutes worth of data in non-volatile memory. The data can be downloaded to a personal computer using a standard serial port and viewed/analyzed by the included software or any standard spreadsheet program:
The standard LM-1 includes a Bosch wide-band oxygen sensor and cable, cigarette-lighter adapter, serial cable for PC connection, 9V battery, exhaust bung and plug, CD and manual. The LM-1 ships with a Bosch sensor, however, it can also function with other wide-band sensors, including Honda/NTK and VW sensors.
The LM-1 kit includes the oxygen sensor (Bosch LSU4.2), 10' sensor cable, 10' power cable, serial PC cable, and software.
More kits and accessories are available here!
Manufacturer: Innovate Motorsports
Click here to visit the manufacturer's home page. |
|
| INN-LM1-KT | Innovate Motorsports LM-1: Digital Air/Fuel Ratio Meter [Photo] [Photo] | No Longer Available | |
| Flare Nut Wrench Set |
| Use the right tool for the job, whether it's replacing or tightening a solid fuel line or even changing out your fuel filter and check valve. Made from SK's high polish SuperKrome finish, that protects the tools from the harsh working environments found in today's workplace, while providing long life and maximum corrosion resistance |
|
TOL-SK376 | 6 Piece SuperKrome Metric Flare Nut Wrench Set [Photo] | $72.50 | |
TOL-SK378 | 6 Piece SuperKrome Metric 15 degree Offset Flare Nut Wrench Set [Photo] | $79.00 | |
