Pelican Parts - Product Information: PEL-TOL-SFJ3

Related Technical Articles:

911 Clutch Cable and Helper Spring Replacement

You should always replace your clutch cable and helper spring prior to performing a clutch job, as the cable often wears out, and could be causing some of your clutch problems. Also covers clutch adjustment.

911 Clutch Replacement

One of our most requested, here is the low-down on how to replace your own clutch in your 901 or 915 equipped 911.

911 Factory Short Shift Kit Install

Bob Tindel offers his usual-excellent approach to installing the factory short-shift kit into your car.

911 G50 Clutch Replacement

Carreras with G50 transmissions need their clutches maintained too! Learn how in this step-by-step article by Jim Smolka.

911 Shifting Improvements

Tired of sloppy shifting in your 911? Try a few of these small suggestions for improving your shift linkage setup.

Full-On 901 Synchro Change!

Rebuilding your transmission might be easier that you think! In this article, Red-Beard goes through a complete, step-by-step teardown of a 901 transmission.

Installing the 911 Factory Short Shift Kit

Here's a step-by-step instruction set on how to install the 911 Factory Short Shift Kit, brought to you by Scott Booth.

Repairing 1st Gear on the 901 Transmission

It's almost typical to have a 901 that crunches or is difficult to get into first gear. The repair is relatively easy, if you have all the right parts.

Click here to see more related articles...

Shifter Rod Seal Replacement

Joe Wolfgang and Wayne team up to offer you an easy solution for replacing your transmission shift rod seal.

Transmission Final Drive Computer

Here is a little program John Rogers wrote to do some speed vs RPM calculations after he did a rally a couple of months ago. It's pretty fun to play around with.

Transmission Gear Ratios

Figure out the exact ratios that you need to figure out for your Porsche with Andrew Warren's 901 & 915 spreadsheets.

Average Customer Review:

(based on 1 reviews)

Reviewed by 1 Customers		Sort by:
	write a review for this item

Indispensible!

By gigi, submitted January 29, 2009

Comments: Can't rebuild a 915 w/o one!

Shift Fork Jig

The shift fork jigs are used to align the forks during a transmission rebuild. It's not recommended that you attempt a rebuild of your transmission without the proper jig. If you assemble the transmission without using these jigs, then you may find that you may have difficulty shifting through gears later on.

Shift Fork Jigs

Rebuilding your transmission? Don't want to pay big bucks for the factory shift fork tooling? You'll do a little dance when you see the savings you get with our repro shift fork jig instead. The plate holds the gear stacks and the carrier for proper alignment and precision.

Kit Parts:

There are no kits associated with this part.

Write a Review: PEL-TOL-SFJ3

Review title:

Overall rating:

How long have you owned this product?

Comments:
(Please give a detailed description of what you liked or disliked about this product)
(2,500 characters max)

Your nickname:

Upload a Photo:

* I have read and agree to abide by the Product Review Guidelines.