Remember which way the original seal goes as it took a while to figure out again the proper placement of this seal. The L shaped end goes into the windshield frame with the lip "up" so that it can catch water. Was very easy to get in except I had to trim 3/4" off each end at an angle. Use a very sharp box cutter. Very high quality rubber.
This site was designed and produced solely by Pelican Parts. Pelican Parts is not associated with Porsche Cars North America in any manner, except for a mutual appreciation and love of the cars. All pictures and references to the Porsche name, and the car names and shapes are for restoration reference only, and do not imply any association with Porsche. Pelican Parts is not responsible for any typographical errors contained within the site. Information and technical articles within this website are for reference only. Consult authorized factory manuals when performing repair procedures. By entering this site, you agree to hold Pelican Parts free from any liability arising out of the use of any information contained within.