Are you looking for a great way to boost the power of your E30? We here at Pelican are pleased to now carry MSDS Header systems for your E30. Why headers? The key to making power in any engine is to make intake and exhaust gases flow quickly and efficiently. The stock exhaust manifolds on the E30 do a good enough job of allowing the exhaust gases to escape the head, however to truly optimize the flow, headers are the only solution. These headers from MSDS are constructed using 16 gauge cold-rolled, mandrel bent steel, and welded on custom jig assemblies assuring a perfect fit. The headers come from MSDS in mild steel, requiring you to paint them to prevent corrosion, or you can opt for MSDS' ceramic coating procedure which assures they will last a lifetime. These headers can be used with a catalytic converter so your car will still meet emissions requirements! Installation requires you to cut the existing exhaust downpipes ahead of the catalytic converter, press in the new downpipes, then weld them in place. Some re-calibration of the air-fuel mixture may be required as well. It is highly recommended that you check the CO% of the exhaust gases after installation. We have tested a set of these headers ourselves and the results are astounding. Mid-range torque of the test car has been greatly improved, along with a deep exhaust tone. Soon to come will be a technical article on the installation procedure. It is also highly recommended that you install a free flow muffler at the same time to truly optimize the exhaust flow. Additional benefits can be realized with the installation of a high-flow cone intake and a performance chip as well. NOTE: Please allow 2-3 weeks for delivery. Ceramic coating will take an additional 2 weeks.
