| Porsche 924S/944/968 Exhaust Pipes - Page 3 |
Air/Fuel Ratio Monitors  |
The K&N Air/Fuel Monitor is designed to help the performance enthusiast calibrate and fine tune the air/fuel mixture ratio. It is an invaluable diagnostic tool that has a place in everyone's tool box, or you can install it in your car to give you real-time readings. This kit continually monitors an engine's air/fuel ratio while the engine is running. It is extremely sensitive to air/fuel ratio changes and will show them instantly and accurately, within the range of the oxygen sensor.
The instrument works whether the engine is carbureted or fuel injected, normally aspirated, turbocharged, or supercharged, and at any load condition. This precision instrument also works with nitrous oxide, but will not work with diesel or nitro-methane fuels. This kit comes complete with an oxygen sensor that must be installed into the exhaust system by welding. If your BMW is already equipped with an oxygen sensor an air/fuel monitor may be purchased separately and wired into the existing electrical system. An oxygen sensor is also available separately.
Vehicles with dual exhaust systems can utilize an oxygen sensor in each headpipe or collector that is controlled by a switch that will allow each sensor or bank of cylinders to be read independently. This can show if there is a fuel distribution problem within the intake system, or help to pinpoint a potential problem in advance. |
|
PEL-SW85-2437 | Rectangle Surface mount Air/Fuel Ratio Monitor Kit, w/oxygen sensor [More Info] | $199.55 |  |
PEL-SW85-2441 | Round In Dash mount Air/Fuel Ratio Monitor Kit, w/oxygen sensor [More Info] | $256.95 | |
PEL-SW85-2439 | Rectangle Surface mount Air/Fuel Ratio Monitor Kit, without oxygen sensor [More Info] | $188.35 | |
PEL-SW85-2442 | Round In Dash mount Air/Fuel Ratio Monitor Kit, without oxygen sensor [More Info] | $217.40 | |
PEL-SW85-2438 | KN Oxygen Sensor, replacement for air/fuel ratio monitor - single wire (includes weld-on fitting) [More Info] | $82.00 | |
PEL-SW85-2440 | O2 Sensor Plug and Fitting [More Info] | $23.60 | |
| PEL-SW85-21688 | Weld on Fitting [More Info] | $14.50 | |
PEL-SW85-21686 | O2 Sensor Plug [More Info] | $16.15 | |
Anti-Seize Lubricant |
| Using a quality anti-seize lubricant now can save you hours of pain-staking work the next time you attempt to remove that old hardware. These premium compounds offer high temperature resistance, corrosion protection, and good electrical conductivity. |
|
2012-M19 | | $8.25 | |
WRTH-8938132 | Wurth CU 1100 Copper Paste, 1 lb [More Info] | $25.00 | |
Wurth Exhaust Assembly Paste |
| Soft paste for fast, easy gas tight sealing of flanges and slip fittings in the exhaust system. No welding necessary. Sets with exhaust heat. Temperature resistant up to approximately 1292° F |
|
WRTH-100045 | Wurth Exhaust Assembly Paste, 140 gram tube [More Info] | $14.95 | |
