| Porsche 928 Pistons, Heads & Valves - Page 5 |
Camshaft Gears |
| Old cam gears can show signs of wear, especially after a timing belt break! Ensure that your rebuild is going to work properly by using only brand new OEM cam gears. |
|
| 928-105-545-04-OEM | Cam Gear, 928 (1978-82), Square teeth
Brand: Genuine Porsche [More Info] | $106.50 |  |
| 928-105-545-14-OEM | Cam Gear, 928 (1983-84), Round Teeth
Brand: Genuine Porsche [More Info] | $242.50 | |
Cam Housing Gaskets |
| Eventually heat and time contribute to the failure of the cam housing gaskets. Keep all of the engine oil in your engine instead of on it. |
|
| 944-105-199-03-M17 | Cam Housing to head Gasket, 2 req, 928 (1978-84),
NOTE: For 928 (1978-81) up to M/T eng# 811 0211 and A/T eng# 811 5201, you must also order quantity 8 of 928-105-427-01 Cam Follower Sleeve Gaskets shown below.
Brand: Victor Reinz [More Info] |  |
| $8.25 | |
| 928-105-427-02-M17 | Cam Follower Sleeve Gasket (sold per each, 8 required), 928 (1978-81), fits up to M/T eng# 811 0211 and A/T eng# 811 5201
Brand: Victor Reinz [More Info] | |
| $1.50 | |
| 928-104-447-06-M17 | Cam Housing to head Gasket (sold per each, 2 required), 928 (1985-86), also use part number 928-104-443-08 Spark Plug Seals shown below
Brand: Victor Reinz [More Info] | |
| $20.75 | |
| 928-104-447-09-M17 | Cam Housing to head Gasket (sold per each, 2 required), 928 (1987-88), also use part number 928-104-443-08 Spark Plug Seals shown below
Brand: Victor Reinz [More Info] | |
| $13.25 | |
| 928-104-443-08-M17 | Spark Plug Seals (sold per each, 8 required), 928 (1985-88)
NOTE: For use with the above Cam Housing Gaskets (1985-88)
Brand: Victor Reinz [More Info] | |
| $2.00 | |
Camshaft Parts |
| Here's the section where all the little miscellaneous cam parts that you need for your engine are located. |
|
| 944-105-501-05-M48 | Cam Chain, OEM replacement (2 per car, sold individually) 928 (1985-On), Each
Brand: IWIS [More Info] | |
| $17.00 | |
| 944-105-501-05-M255 | Cam Chain, High-Performance (2 per car, sold individually) 928 (1985-On), Each
Brand: IWIS Racing [More Info] | |
| $22.50 | |
| 928-105-205-00-M737 | Retainer for Cylinder Head Plug, 928 (1985-95) (6 per car, sold individually)
Brand: Hamburg Technic [More Info] | |
| $4.25 | |
| 928-105-215-00-M204 | Cylinder Head Plug (Camshaft End), 928 (1985-95) (6 per car, sold individually)
Brand: Kaco [More Info] | |
| $6.00 | |
| 944-105-199-03-M17 | Cam Tower Gasket, 928 (1978-84)
Brand: Victor Reinz [More Info] | |
| $8.25 | |
| 928-105-189-02-M17 | Cork Gasket - Cam Tower Rear, 928 (1978-84) (2 per car, sold individually)
Brand: Victor Reinz [More Info] | |
| $1.00 | |
| 999-701-602-40-M17 | O-Ring Camshaft Large, 928 (1980-84)
Brand: Victor Reinz [More Info] | |
| $0.75 | |
| 999-701-592-40-M17 | O-Ring Camshaft Small, 928
Brand: Victor Reinz [More Info] | |
| $1.00 | |
| 999-113-282-40-M17 | | $5.75 | |
| 928-105-139-02-M260 | Flange for Camshaft Seal, 928 (through 1984)
Brand: OEM [More Info] | |
| $22.00 | |
| 900-067-214-01-M100 | Camshaft Housing Bolt (8 x 35 mm), 928 (1978-84) (30 per car, sold individually), Each
Brand: Genuine Porsche [More Info] | |
| $5.75 | |
| 944-606-170-02-M14 | Hall Sender (Cam Position Sensor), 928 Right Camshaft (from 1987), Each
Brand: Bosch [More Info] | |
| $131.75 | |
