| Porsche 914 Axles & Bearings - Page 2 |
Wheel Bearings  |
| Wheel bearings are one of the parts that routinely wear out on older cars. With the car off the ground, check the wheel for any wobbling or excessive noise. Replace bearings in pairs. Tech Tip: Freeze the rear bearings prior to installation. The cold temperatures will make them shrink slightly and be easier to press in. They also make a nice snack when served with ice cream. |
|
| Front Wheel Bearings |
311-405-645-M92 | Front Outer Wheel Bearing, 2 Per Car, 914 1.7/1.8/2.0 (1970-76), Each
Brand: SKF [Photo] [Photo] |  |
| $14.75 |  |
311-405-625D-M92 | Front Inner Wheel Bearing, 2 Per Car, 914 1.7/1.8/2.0 (1970-76), Each
Brand: SKF [Photo] [Photo] | |
| $8.75 | |
999-059-065-00-M92 | Front Outer Wheel Bearing, 2 Per Car, 914-6 (1970-72), Each
Brand: SKF [Photo] [Photo] | |
| $10.25 | |
999-059-098-00-M92 | Front Inner Wheel Bearing, 2 Per Car, 914-6 (1970-72), Each
Brand: SKF [Photo] [Photo] | |
| $8.75 | |
| Front Wheel Seals |
311-405-641B-M213 | Front Wheel Seal, 2 Per Car, 914 1.7/1.8/2.0 (1970-76), Each
Brand: D P H [Photo] [Photo] | |
| $8.00 | |
| Front Wheel Seal, 2 Per Car, 914-6 (1970-72), Each |
477-405-641-M30 | Front Wheel Seal, 2 Per Car, 914-6 (1970-72), Each
Brand: Elring Klinger [Photo] | |
| $3.50 | |
477-405-641-M204 | Front Wheel Seal, 2 Per Car, 914-6 (1970-72), Each
Brand: Kaco [Photo] [Photo] | |
| $7.00 | |
| Rear Wheel Bearings |
999-053-035-00-M92 | Rear Wheel Bearing, 2 Per Car, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-71), Each
Brand: SKF [Photo] [Photo] | |
| $79.75 | |
914 4 Lug to 5 Lug Adapters |
914 5 Lug wheel conversion's are very popular and will set your 914 out from the crowd, but the high cost of re-studding your rotors and hubs, plus the down time has always been the limiting factor in upgrading your 914's look.
These New 914 4 to 5 lug Adapter allows you to upgrade to 5 lug wheels in a matter of hours and at a low cost, plus you get the added benefit of widening your track, improve your handling and will fill out your fender wells. The Adapters are Hub-centric and have a staggered stud design allowing easy bolt on installation.
These adapters are the perfect, cost effective answer for adding wider 5 lug wheels to your GT fendered 914. 914's with stock fenders may need to roll fender lips due to the additional width of the adapter. These Adapters require the use of one Special Length Chrome Lug Bolt per adapter. Note: Chrome Alloy Lug Nut, PEL-7075CS is the perfect match to the required Special Length Chrome lug bolt. |
|
PEL-RB5005 | 914 4 Lug to 5 Lug Adapters w/Special Chrome Lug Bolt, each [Photo] | $119.25 | |
PEL-7075CS | Aftermarket Alloy Lug Nut, Chrome (sold per each) [Photo] | $6.20 | |
Wheel Spacers/Adapters |
| Wheel Spacers/Adapters will widen your track, improve your handling and fill out your fender wells. Staggered stud design allows easy bolt on installation. These wheel spacers/adapters are hub-centric with ball seating and come with studs. 5 lug applications only. |
|
PEL-WS-4MM | 4 mm Wheel Spacer (can be used with stock length studs), each [Photo] | $23.10 | |
PEL-WS-5MM | 5 mm Wheel Spacer (can be used with stock length studs), each [Photo] | $23.10 | |
| PEL-WS-014 | 1/4 inch (6.5mm) Wheel Spacer Only, 5 lug (sold per each)
(can be used with stock length studs) | $23.10 | |
PEL-WS-10MM | 10 mm Wheel Spacer, each [Photo] | $48.00 | |
| PEL-PP912309 | 1/4 inch Weltmeister 4-Lug Wheel Spacer Kit (set of 2), 914-4 (1970-76)
(can be used with stock length studs) | $49.98 | |
PEL-WS-810 | 0.8 inch (21 mm) Wheel Spacer/Adapter, each [Photo] | $119.25 | |
| PEL-WS-001 | 1 inch Wheel Spacer/Adapter (5 lug), each | Temporarily unavailable | |
| PEL-WS-015 | 1.5 inch Wheel Spacer/Adapter (5 lug), each | $120.00 | |
| PEL-WS-002 | 2 inch Wheel Spacer/Adapter (5 lug), each | $138.30 | |
PEL-WS-003 | 3 inch Wheel Spacer/Adapter (5 lug), each [Photo] | $181.90 | |
