| Porsche 914 Rear End Seals - Page 1 |
[Click to Enlarge] |
|
| At Pelican Parts, we don't believe in selling any product that we personally wouldn't put on our own cars. That is why we have chosen not to carry reproduction 914 seals. As we have seen in the past, these seals are not of very high quality, and often leak or perform poorly. The seals we stock are high quality German seals that are OEM or better. We stand behind the products that we sell, and don't want to sell poor quality products. If you have any questions about 914 seals, please feel free to contact us. |
|
-A- Rear Bumper Guards  |
| These are the rubber tips that attach to the bumper to help minimize the damage when that idiot bumps you from behind. |
|
| 914-505-085-10-OEM | Rear Bumper Guard, Left, 914 1.8/2.0 (1974), Each
Brand: Genuine Porsche | No Longer Available | |
| 914-505-086-10-OEM | Rear Bumper Guard, Right, 914 1.8/2.0 (1974), Each
Brand: Genuine Porsche | $70.50 |  |
| 914-505-191-10-OEM | Rear Bumper Guard, Left, 914 1.8/2.0 (1975-76), Each
Brand: Genuine Porsche | $59.25 | |
| 914-505-192-10-OEM | Rear Bumper Guard, Right, 914 1.8/2.0 (1975-76), Each
Brand: Genuine Porsche | $61.25 | |
-B- Rear Bumper Pads |
| This is the long strip of rubber that sits on top of the bumper for the early cars, and completely surrounds the bumper on the later cars. |
|
914-503-027-10-M136 | Rear Bumper Pad, 914 1.7/1.8/2.0 (1970-74), 914-6 (1970-72), Each
Brand: OEM [Photo] |  |
| $429.50 | |
| 914-503-233-10-OEM | Rear Bumper Pad, 914 1.8/2.0 (1975-76), Each
Brand: Genuine Porsche | $649.25 | |
-C- Rear Trunk Seals |
| This is the seal that runs along the 3 edges of the trunk, keeping water from entering the trunk. When water enters the trunk it typically collects in the bottom rear of the trunk and starts to rust the panel. |
|
914-512-317-10-M260 | Rear Trunk Seal, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-72), Each
Brand: OEM [Photo] [Photo] | |
| $68.00 | |
-D- Rear Window Seals |
| This is the seal that bridges the gap between the rear window and the front part of the engine decklid. |
|
914-512-319-10-M260 | Engine Lid Seal, Between Rear Glass and Engine Lid, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-72), Each
Brand: OEM [Photo] [Photo] | |
| $44.50 | |
-E- Rear Targa Seals |
| This 'C' shaped seal screws to the rear of the targa top and helps to seat the top to the 914 rollbar. A good rear seal can help prevent wind noise, and that terribly unpleasant squeaking noise that the roofs sometimes make. |
|
914-563-077-11-OEM | Rear Targa Seal, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-72), Each
Brand: Genuine Porsche [Photo] | $463.25 | |
-F- Vent Window Caps |
| This little rubber part tops off the small triangular window in the front part of the door. |
|
| PCG-542-017-10-OEM | Vent Window Cap, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-72), Each
Brand: Genuine Porsche | $80.50 | |
-G- Vent Wing Glass Seals |
| This seal mates the small triangular window to the bottom of the door frame, and runs up the side of the car. |
|
914-542-325-10-M100 | Vent Wing Glass Seal, Left, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-72), Each
Brand: Genuine Porsche [Photo] | |
| $104.75 | |
914-542-326-10-M100 | Vent Wing Glass Seal, Right, 914 1.7/1.8/2.0 (1970-76), 914-6 (1970-72), Each
Brand: Genuine Porsche [Photo] | |
| $82.00 | |
)
