Order Online or Call:  
888-280-7799  
HACKER SAFE certified sites prevent over 99.9% of hacker crime.
  Search our site:   

View Cart  | Project List | Order Status |  Help    

 
- Back to Catalog -
Heater Hoses
Blower Motors
Fresh Air Blower Motor, Hoses & Hardware
Resistors
Air Block-Off Plates
Heater Ducts
Heater Pull Cables
Heater Flapper Boxes
Fan Shroud Heater Outlet
Fasteners
- Back to Catalog -
Home >  911 Catalog911 (1974-89)Ventilation & A/C >   Porsche 911 & Carrera Heating & Ventilation 
Porsche 911 & Carrera Heating & Ventilation - Page 2

Resistors

911-616-011-00-OEM

Resistor with Harness, 911 Carrera (1984-89)
   Brand: Genuine Porsche

$164.75

Air Block-Off Plates

The 911 engine is an air-cooled engine. As such, it receives much of its cooling via the flow of air from the large upright fan mounted on the engine. Improving the flow of the air helps to keep the engine running cooler, which translates into increased longevity. Since the 911 uses its fan to supply air for the passenger compartment heating system, some of this air is diverted away from cooling the engine. With air cooled cars, the passenger compartment heat comes from air blown through sheet metal passages that surround the exhaust headers.

If your heater in your 911 is not working or is disabled, then you might want to install what is commonly known as an air block-off plate on the side of the engine fan. Towards the left side of the engine, there is an air outlet that drives the heating system for the car. On the early cars, this flow of air was the only mechanism to push air into the passenger compartment. This arrangement didn’t provide adequate warm air flow and in later years, Porsche installed an additional blower motor in the engine compartment. If your heater system is not working or disabled (as it usually is on a track car), then a good upgrade is to replace your heater air-flow plate with a block-off plate. This block-off plate does exactly what its name implies. It blocks the flow of air, and thus diverts it back over the cylinders, where it can cool the car.

911-106-036-01-OEM

Air Block-Off Plate, Right, Metal, 911 (1965-89)
   Brand: Genuine Porsche    [Photo]

$36.00

PEL-PP910181

Air Block-Off Plate, Left, Fiberglass, 911 (1965-89), Not pre-drilled for hardware    [Photo]

$84.95

Heater Ducts

These metal reproduction heater ducts are very well made and look fantastic. These ducts fit 911s from 1965-74, and 1975-89 911s with backdated heat.

930-106-321-01-PH

Left Side Heater Duct, 911 (1965-74) (1975-89 for backdated heater) NOTE: May need to be tapped with hammer near mounting screws to achieve optimal fit.    [Photo]

$94.95

911-106-322-01-PH

Right Side Heater Duct, 911 (1965-74) (1975-89 for backdated heater) NOTE: Will require modification for cars with air conditioning    [Photo]

$89.95

Heater Pull Cables

Is your heater cable frayed, broken, or missing altogether? Perhaps one of the little tips have fallen off of the end, so that you can't reconnect it to the flapper boxes? Fix your heater system once and for all with a brand new cable. Also replace your heater barrel nuts if they are missing from the flapper boxes.

901-424-701-05-M74

Heater Cable (only 1 req.), 911 (1974), 912E (1976)
   Brand: Gemo    [Photo] [Photo]

$3.25

911-424-701-01-M260

Heater Cable, 911 with Manual Heat Control (sold per each, 2 req.), 911 (1975-86)
   Brand: OEM    [Photo]

$11.00

911-424-701-02-M260

Heater Cable, 911 with Auto-Heat (only 1 req.), 911 (1978-86)
   Brand: OEM    [Photo]

$12.75

911-211-683-00-M100

Clamping Bolt for Heater Cable (at heater control box), 2 per car, sold per each, 911 and 911 turbo (1987-89)
   Brand: Genuine Porsche    [Photo]

$13.00

Heater Flapper Boxes

Don't get left out in the cold! Have your old flapper boxes become rusted, stuck, or has the pull lever broken off? Replace them with brand new ones and assure that your heat will be working fine for many years to come.

911-211-013-00-M260

Heater Flapper Box, left, without auto-heat, 911 (1974-86)
   Brand: OEM    [Photo] [Photo]

$146.75

911-211-014-00-M260

Heater Flapper Box, right, 911 (1974-89)
   Brand: OEM    [Photo] [Photo]

$144.25

901-211-051-21-OEM

Heater Box Clamp, left, without auto-heat, 911 (1974-86)
   Brand: Genuine Porsche    [Photo]

$14.75

901-211-052-21-OEM

Heater Box Clamp, right, 911 (1974-89)
   Brand: Genuine Porsche    [Photo]

$14.75

900-378-030-09-OEM

Bolt (sold per each, 2 req.), 911 (1974-89)
   Brand: Genuine Porsche    [Photo]

$1.00

N-012-006-4-OEM

Lock Ring (sold per each, 2 req.), 911 (1974-89)
   Brand: Genuine Porsche    [Photo]

$0.75
930-211-622-01-M260

OE Connecting Hose (sold per each, 2 req.), 911 and 911 Turbo (1974-89)
   Brand: OEM    [Photo] [Photo]

$28.50
930-211-622-01-M260

Aero Space Connecting Hose, 12 in. (sold per each, 2 req.), 911 (1974-89)
   Brand: OEM    [Photo] [Photo]

$28.50

999-512-349-02-OEM

Connecting Hose Clamp (sold per each, 2 req.), 911 (1974-89)
   Brand: Genuine Porsche    [Photo]

$2.50

911-211-297-00-M260

Heater Box Gasket (sold per each, 2 req.), 911 (1974-89)
   Brand: OEM    [Photo] [Photo]

$4.25

A-084-010-02

Heater Box Nut (sold per each, 6 req.), 911 (1974-89)    [Photo]

No Longer Available 

A-025-004-02

Heater Box Washer (sold per each, 6 req.), 911 (1974-89)    [Photo]

No Longer Available 

911-659-119-00-OEM

Heater Box Connecting Piece (sold per each, 2 req.), 911 (1974-89)
   Brand: Genuine Porsche    [Photo]

No Longer Available 

  Page 2 of 3  <123>

        

  Search our site:   

View Cart & CheckOut | Project List | Order Status |  Help    

 

[Home] [Customer Service] [Shopping Cart] [Project/Wish List]
  [Privacy Statement]  [Contact Us] [About Us] [Shipping]

Copyright © 2009, Pelican Parts Inc.