| Porsche 911 & Carrera Tools - Page 7 |
Synchrometer |
| Synchronizing your Porsche mechanical fuel injection or carburetors with our tool, is the only way to precisely measure the air intake for optimum power and a smooth idle. |
|
PEL-TOL-STESK | Mechanical Injection/carburetor Synchrometer [More Info] | $55.80 |  |
Float Gauge |
PEL-PMO-004 | Float Gauge by PMO, for Weber and Zenith 3-bbl carbs [More Info] | $34.00 | |
Allen Head Tools |
| Removing your 911 heads or heat exchangers can be very difficult without the correct tools for the job. With these extra long Allen extensions, those nuts can't hide. The 10mm tool is used for removing and tightening the head studs on the 911 motor. The 8mm tool is used to remove and tighten the 911 heat exchanger nuts. |
|
PEL-TOL-A10MM | Allen Head Nut Removal Tool for 911 Head Studs (10mm) [More Info] | $29.95 | |
PEL-TOL-P243 | Allen Heat Exchanger Nut Removal Tool (8mm) [More Info] | $29.40 | |
Magnetic Box "V" Wrench (17mm) |
| This unique-looking tool is used to aid in the removal of the engine/transmission bolts. The V-Wrench holds the nut on the other side of the engine compartment so that you can remove the nut from the transmission. The V design holds the nut steady, unlike a normal wrench, and allows you to remove the bolt on the other side without the help of an assistant. |
|
PEL-TOL-P222 | Magnetic Box "V" Wrench (17mm) [More Info] | $31.00 | |
Suspension Alignment Tools |
| Doing some adjustments to your suspension? Using the right tools can help you obtain exactly the values that you are looking for. |
|
PEL-TOL-P221 | Rear Suspension Toe-In Adjuster, 911 All [More Info] | $26.80 | |
PEL-TOL-P235 | Camber Adjuster, 911, C2 and C4 [More Info] | $21.60 | |
Ride Height Wrench |
| don't be without this Ride Height Combination Wrench went setting up your suspension! Fits the spring plate eccentric 24mm and 36mm bolts. Powder coated for a long lasting finish. |
|
PWE-2436RHW | Ride Height Combination Wrench, 911 1977-89 [More Info] | $30.70 | |
Extraction Tools |
| Nothing beats the frustration of trying to remove something that isn't going anywhere. Do the job right by using the right tools to remove that gear or bushing. These pullers are designed to properly remove what they were designed to remove, without damaging anything else. |
|
PEL-TOL-P229 | Distributor Drive Gear Puller, 912, 914, 356 [More Info] | $25.20 | |
PEL-TOL-P236 | Oil Piston Pressure Relief Valve Puller, 912, 914, 356 [More Info] | $27.70 | |
PEL-TOL-P239 | Starter Bushing Puller, 12V [More Info] | $31.00 | |
PEL-TOL-P238 | Starter Bushing Puller, 6V [More Info] | $31.00 | |
PEL-4491B | Oxygen Sensor Removal Tool, 22mm, 3/8" drive [More Info] | $21.80 | |
