The kit comes with a set of adapters specific to the Porsche series, but can also be used on all front and rear wheel drive vehicles with independent suspension. Also for R&R of the rear wheel bearings only on models with drum brakes independent rear suspension.

The Metric Dial Gauge is a requirement for setting the sensitive timing adjustment of the cams when rebuilding a 911 motor. It's also essential when measuring the flywheel and crank shaft end play. The Z-block fixture is designed to hold the dial gauge while adjusting the 911 camshaft timing, and also comes with a dial gauge extension pin. The Dial Gauge Holder is designed to hold the gauge while measuring flywheel and pulley end play.

The Camshaft Socket, Cam Bar, and 46mm Crows Foot Wrench are absolute essentials when assembling or tearing apart your 911 engine. The Camshaft nut that secures the timing requires almost 200 ft-lbs of torque, two people, and the right tools to remove. Attempting to remove this nut without the proper tools can result in damage to your engine!

The spring clips are used to secure the cam followers (tappets) inside the case while you are assembling it. Very often, these will fall out as you rotate and move the case around. Protect them from damage by installing these retaining clips.

The chain sprocket holder is a much more secure method of retaining the chain when you perform a tensioner replacement. Designed to prevent the chain from slipping off the Camshaft sprocket, this tool can be an invaluable life saver. Also used during the upgrade process is the chain tensioner tool, which holds the chain tensioners in their compressed position so that they may be easily installed in the engine.