| Porsche 911 & Turbo CIS Fuel Injection - Page 16 |
Accessories & Performance |
| Swepco 503 Fuel Improver |
| Restore lost power and clean your Fuel Injection or Carburetors. Removes impurities and particle build up. Drive your engine clean! |
|
SWE-503 | Swepco 503 Fuel Improver, 12oz [More Info] | $6.85 |  |
| Air/Fuel Ratio Monitors |
The K&N Air/Fuel Monitor is designed to help the performance enthusiast calibrate and fine tune the air/fuel mixture ratio. It is an invaluable diagnostic tool that has a place in everyone's tool box, or you can install it in your car to give you real-time readings. This kit continually monitors an engine's air/fuel ratio while the engine is running. It is extremely sensitive to air/fuel ratio changes and will show them instantly and accurately, within the range of the oxygen sensor.
The instrument works whether the engine is carbureted or fuel injected, normally aspirated, turbocharged, or supercharged, and at any load condition. This precision instrument also works with nitrous oxide, but will not work with diesel or nitromethane fuels. This kit comes complete with an oxygen sensor that must be installed into the exhaust system by welding. If your 911 is already equipped with an oxygen sensor (1980-89), an air/fuel monitor may be purchased separately and wired into the existing electrical system. An oxygen sensor is also available separately.
Vehicles with dual exhaust systems (like the 911) can utilize an oxygen sensor in each headpipe or collector that is controlled by a switch that will allow each sensor or bank of cylinders to be read independently. This can show if there is a fuel distribution problem within the intake system, or help to pinpoint a potential problem in advance. |
|
PEL-SW85-2437 | Rectangle Surface mount Air/Fuel Ratio Monitor Kit, w/oxygen sensor [More Info] | $199.55 | |
PEL-SW85-2441 | Round In Dash mount Air/Fuel Ratio Monitor Kit, w/oxygen sensor [More Info] | $206.30 | |
PEL-SW85-2439 | Rectangle Surface mount Air/Fuel Ratio Monitor Kit, without oxygen sensor [More Info] | $137.27 | |
PEL-SW85-2442 | Round In Dash mount Air/Fuel Ratio Monitor Kit, without oxygen sensor [More Info] | No Longer Available | |
PEL-SW85-2438 | KN Oxygen Sensor, replacement for air/fuel ratio monitor - single wire (includes weld-on fitting) [More Info] | $82.00 | |
PEL-SW85-2440 | O2 Sensor Plug and Fitting [More Info] | $23.60 | |
| PEL-SW85-21688 | Weld on Fitting [More Info] | $10.50 | |
PEL-SW85-21686 | O2 Sensor Plug, 18mm x 1.5
Brand: K&N [More Info] | $16.15 | |
| O2PLUG-M18-KIT | O2 Sensor Plug, 18mm x 1.5 [More Info] | $5.00 | |
Electromotive Distributorless Engine Management Systems |
| Electromotive is the system for high performance. The Electromotive systems can replace just your distributor, or replace your entire out-dated fuel injection system. The system most used by serious racers, Electromotive products mean real performance. Read on for more details, or visit the Electromotive Electronics website. |
|
| Distributorless XDi Ignition Kits |
Replace your worn out distributor with an Electromotive XDi crank-fired, high-energy, high-resolution ignition adapted to fit your Porsche. Compared to the cost of a new replacement distributor, the advantages of this newer technology really comes down to earth. Kits include: XDi ignition, wire harness, crank sensor, crank trigger adapter (pulley, trigger wheel, sensor mount, distributor hole plug), and instructions.
XDI delivers more power:- Spark timing is precisely controlled under all conditions, including rapid engine acceleration
- Crank trigger eliminates spark scatter due to gear lash and timing chain stretch
- Accurate spark timing allows sustained engine operation closer to peak power
- timing
- 100% spark energy to 9600 RPM on 6 cylinder and 12,000 RPM on 4 & 8 cylinder applications (at 12 volts)
- Operation up to 20,000 RPM (at higher battery voltage)
- Long, 1000+ microsecond spark duration - 60+° duration at 10,000 RPM!
- Built-in timing computer and rev limiter
- No power draining magnetos or distributors to drive
- No moving parts to wear out or replace
- Built-in timing monitor lets you measure the advance with a voltmeter
- Options include: backup sensor, dual rev limiter, and remote timing control
|
|
| CE-9005-116 | XDi Single Plug Ignition Kit, 911 Kit with 116mm pulley [More Info] | $1299.00 | |
CE-9006-116 | XDi Dual Plug Ignition Kit, 911 Kit with 116mm pulley [More Info] | $1329.00 | |
| CE-9005-127 | XDi Single Plug Ignition Kit, 911 Kit with 127mm pulley [More Info] | $1299.00 | |
CE-9006-127 | XDi Dual Plug Ignition Kit, 911 Kit with 127mm pulley [More Info] | $1329.00 | |
| CE-9005-131 | XDi Single Plug Ignition Kit, 911 Kit with 131mm pulley [More Info] | $1299.00 | |
CE-9006-131 | XDi Dual Plug Ignition Kit, 911 Kit with 131mm pulley [More Info] | $1329.00 | |
| CE-9005-10 | XDi Single Plug Ignition Kit, 911 Kit 2.0-3.3 w/ Rotary A/C Compressor [More Info] | $1299.00 | |
CE-9006-10 | XDi Dual Plug Ignition Kit, 911 Kit 2.0-3.3 w/ Rotary A/C Compressor [More Info] | $1359.00 | |
| CE-9005-11 | XDi Single Plug Ignition Kit, 911 Kit 2.0-3.3 w/ York A/C Compressor [More Info] | $1299.00 | |
CE-9006-11 | XDi Dual Plug Ignition Kit, 911 Kit 2.0-3.3 w/ York A/C Compressor [More Info] | $1359.00 | |
CE-9006-20 | XDi Dual Plug Ignition Kit, 964 Kit 3.6 liter tapered crank 2 groove 127mm diameter pulley [More Info] | $1359.00 | |
CE-9006-25 | XDi Dual Plug Ignition Kit, 964 Kit 3.6 liter tapered crank hub for use with stock pulleys [More Info] | $1269.00 | |
CE-9006-21 | XDi Dual Plug Ignition Kit, 993 Kit 2 groove 127mm diameter pulley [More Info] | $1359.00 | |
