| Porsche 911 Tools - Page 7 |
Timing Sprocket Registration Pin Puller |
PEL-STSK-SR026 | Stomski Racing Sprocket Registration Pin Puller, each, 911 (1965-98) [More Info] | $34.80 |  |
944/968 Flywheel Lock |
| This lock is required after you replace the front oil seal and need to retorque the front pulley. Also required during clutch changes in order to remove the flywheel bolts. |
|
PEL-TOL-P233 | 944 Flywheel Lock [More Info] | $44.50 | |
000-721-920-61-OEM | 968 Flywheel Lock
Brand: Genuine Porsche [More Info] | $67.75 | |
Synchrometer |
| Synchronizing your Porsche mechanical fuel injection or carburetors with our tool, is the only way to precisely measure the air intake for optimum power and a smooth idle. |
|
PEL-TOL-STESK | Mechanical Injection/carburetor Synchrometer [More Info] | $55.80 | |
Float Gauge |
PEL-PMO-004 | Float Gauge by PMO, for Weber and Zenith 3-bbl carbs [More Info] | $34.00 | |
Allen Head Tools |
| Removing your 911 heads or heat exchangers can be very difficult without the correct tools for the job. With these extra long Allen extensions, those nuts can't hide. The 10mm tool is used for removing and tightening the head studs on the 911 motor. The 8mm tool is used to remove and tighten the 911 heat exchanger nuts. |
|
PEL-TOL-A10MM | Allen Head Nut Removal Tool for 911 Head Studs (10mm) [More Info] | $29.95 | |
PEL-TOL-P243 | Allen Heat Exchanger Nut Removal Tool (8mm) [More Info] | $29.40 | |
Magnetic Box "V" Wrench (17mm) |
| This unique-looking tool is used to aid in the removal of the engine/transmission bolts. The V-Wrench holds the nut on the other side of the engine compartment so that you can remove the nut from the transmission. The V design holds the nut steady, unlike a normal wrench, and allows you to remove the bolt on the other side without the help of an assistant. |
|
PEL-TOL-P222 | Magnetic Box "V" Wrench (17mm) [More Info] | $31.00 | |
Suspension Alignment Tools |
| Doing some adjustments to your suspension? Using the right tools can help you obtain exactly the values that you are looking for. |
|
PEL-TOL-P221 | Rear Suspension Toe-In Adjuster, 911 All [More Info] | $26.80 | |
PEL-TOL-P235 | Camber Adjuster, 911, C2 and C4 [More Info] | $21.60 | |
Ride Height Wrench |
| don't be without this Ride Height Combination Wrench went setting up your suspension! Fits the spring plate eccentric 24mm and 36mm bolts. Powder coated for a long lasting finish. |
|
PWE-2436RHW | Ride Height Combination Wrench, 911 1977-89 [More Info] | $30.70 | |
