| Porsche 356 Carburetion - Page 2 |
Fuel Pump |
| Carburetor Fuel Pump |
| Increase your engine's performance with a Rotary Fuel Pump. You can run it with leaded or unleaded gasoline. Hot fuel boosters won't faze it. It's a rotary so it runs quiet and smooth without fuel surge. An internal pressure regulator supplies a constant 3 1/2 lbs. of uninterrupted fuel pressure at up to 30 gallons per hour. Each Rotary pump is supplied with a complete mounting kit and instructions. NOTE: Use with Weber carbs only. |
|
PEL-CB3193 | Deluxe Electric Fuel Pump, w/ fuel filter (3.5 lbs pressure) 356 with Weber carbs [More Info] | $69.20 |  |
Fuel Pump Rebuild Kits |
| We offer two types of rebuild kits for the 356 |
|
| NLA-108-903-00 | Fuel Pump Rebuild Kit 356A/B, (1960-62)
Brand: Stoddard Reproduction [More Info] | $85.95 | |
| NLA-108-903-01 | Fuel Pump Rebuild Kit 356C, (1963-65)
Brand: Stoddard Reproduction [More Info] | $28.80 | |
Fuel Pump Blocks |
| 616-108-441-00-M260 | Fuel Pump Block, 356B/C (1962-65)
Brand: OEM [More Info] |  |
| $31.25 | |
Fuel Filters |
| It's a good idea to change your fuel filter every 7000 to 8000 miles to ensure clean fuel running to the carburetor. |
|
| 311-133-511-D-M67 | Fuel Filter, 356B/356C (1960-65)
Brand: Mahle [More Info] | |
| $8.00 | |
13-32-1-278-272-M45 | Fuel Filter, Inline Plastic with 6/8 mm Inlet and 6/8 mm Outlet, 356 with Zenith (1955-65)
Brand: Hengst [More Info] | |
| $1.50 | |
Fuel Tank Level Sensors |
| This is the sender inside the fuel tank. A faulty sender can cause false fuel readings causing you to think you have gas right before you run out! |
|
| 644-201-801-07 | Fuel Tank Level Sensor 356C (1964-65)
Brand: VDO [More Info] | No Longer Available | |
Fuel Tanks |
| It's not uncommon for fuel tanks to rust inside causing fuel contamination and eventually rusting through the tank. Replace yours with a new factory tank. |
|
| 644-201-001-07-M321 | | $1478.75 | |
Fuel and Oil Caps |
901-201-271-00-M100 | Fuel Cap (includes new seal), 356 (1964-65)
Brand: Genuine Porsche [More Info] | |
| $22.25 | |
PCG-207-271-00-M260 | | $18.50 | |
930-107-272-01-M260 | Cap Seal, Fuel Cap: 356 (1964-65), Oil Cap: 356
Brand: OEM [More Info] | |
| $1.75 | |
Digital Air/Fuel Ratio Meter |
The LM-2 combines an air/fuel ratio meter, a full-function 32-channel datalogger, and powerful software to deliver a complete tuning workshop for less than the cost of one dyno day. Whether you have a piggy-back fuel controller, race carb, aftermarket ECU, ODB-II tuning software, or a flash/chip programmer, an LM-2 is the tool you need to dial in maximum HP. The meter’s digital signal processing technology provides data on exactly how rich or lean an engine is running at any load. The LM-2’s self-calibrating circuitry also compensates for changes in temperature, altitude, and sensor condition. - Patented “Direct Digital” Wideband Technology
- Wideband O2 Compatible with ALL fuel types
- Single or Dual Channel Version Available
- OBD-II Scan tool- read/clear DTCs and log up to 16 channels of CAN OBD-II Data
- Log directly to SD card (included)
- Playback log data on screen and/or with powerful LogWorks software (included)
- Large high-contrast graphics LCD
- Built-in RPM converter (direct frequency or with optional inductive clamp)
- 4 fully-differential analog inputs
- 2 configurable linear analog outputs
- Positive lock connectors for all connections
- Innovate MTS serial IN and OUT
- USB connection to your PC
The LM-2 also features two fully programmable linear analog outputs to connect to analog gauges, dyno computers, ECUs, piggyback controllers, and other devices with analog inputs. Analog output 1 comes setup from the factory ready for narrowband simulation; analog output 2 is configured as 0 volt = 7.35 AFR and 5 volts = 22.39 AFR. With the provided LM Programmer software these analog outputs may also be configured by the user.
The LM-2 Kit (Single Wideband O2) includes the LM-2 meter, Bosch wide-band oxygen sensor, 10 ft sensor cable, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. Carrying Case also included!
More accessories for your LM-1 available here.
For permanently installed tuning solutions, click here.
Manufacturer: Innovate Motorsports
Click here to visit the manufacturer's home page. |
|
INN-3806 | Innovate Motorsports LM-2: Digital Air/Fuel Ratio Meter [More Info] | $479.00 | |
