Parts Catalog Accessories Catalog Tech Info Tech Forums
  Search our site:    
View Recent Cars  |   Cart  | Project List | Order Status | Help    
BMW 2800, 3.0, Bavaria (1968-1976)
BMW Home > BMW 2800, 3.0, Bavaria (1968-1976) > ExhaustExhaust Pipes, Manifolds & EGR  

Exhaust Pipes, Manifolds & EGR - Page 1

Oxygen Sensors
The oxygen sensor actively measures the exhaust output from the engine in order to determine the proper mixture for the car. If you are having trouble adjusting the mixture on your car to proper levels, there is a high chance that you may have a faulty oxygen sensor. The oxygen sensor is located before the catalytic converter because the air/fuel mixture ratio cannot be accurately calculated after the exhaust gases have been processed through the CAT. It's also highly recommended that you check out our Pelican Technical Article on Replacing Oxygen Sensors.
Oxygen Sensor Removal Tools
Are you having trouble removing the oxygen sensor? Many times, it is not possible to get a wrench or socket around the sensor due to its location in the exhaust. Once again, Pelican has your answer. This special tool allows you to remove the oxygen sensor using a standard 3/8" drive ratchet, simplifying an otherwise difficult job.
Oxygen Sensor Removal Tool, 22mm, 3/8 in. drive
- 2800, 3.0S and Bavaria Sedan (1974)
- 3.0CS and 3.0CSi Coupe (1974)
- 3.0Si Sedan (1975-76)
    [More Info]
 (9 customer reviews)
Part Number: PEL-4491B
Anti-Seize Products
Plan ahead for when you will be removing the hardware. Use an anti-seize product today and prevent headaches tomorrow!
Using a quality anti-seize lubricant now can save you hours of pain-staking work the next time you attempt to remove that old hardware. These premium compounds offer high temperature resistance, corrosion protection, and good electrical conductivity.
Wurth CU 1800 Extreme Pressure Lubricant, 1 lb
    [More Info]
Part Number: WRTH-0893180016
Assembly Paste
Soft paste for fast, easy gas tight sealing of flanges and slip fittings in the exhaust system. No welding necessary. Sets with exhaust heat. Temperature resistant up to approximately 1292 deg F
Wurth Exhaust Assembly Paste, 140 gram tube
    [More Info]
 (2 customer reviews)
Part Number: WRTH-100045

BMW Home  >  BMW 2800, 3.0, Bavaria (1968-1976) > Exhaust  >  Exhaust Pipes, Manifolds & EGR  

  Page 1 of 1  1

  Search our site:    
   Cart  | Project List | Order Status | Help    

[Home] [Customer Service] [Shopping Cart] [Project/Wish List]
  [Privacy Statement]  [Contact Us] [About Us] [Shipping]

Copyright 2012, Pelican Parts Inc. -    DMCA Registered Agent Contact Page

Page last updated: Wed 10/22/2014 9:03:01 PM