Parts Catalog Accessories Catalog Tech Info Tech Forums
 
  Search our site:    
View Recent Cars  |   Cart  | Project List | Order Status | Help    
Porsche 911 (1989-1998)
 
Porsche Home > Porsche 911 (1989-1998) > InteriorSeats, Belts & Upholstery 

Seats, Belts & Upholstery - Page 1

Seats
Seat Belts and Parts
Seat belt digging into you a little too much? One solution is to add a wrap-around pad to your shoulder belt. We have a few varieties to offer you - from the somewhat subtle charcoal grey, to the bright red MOMO belt pad - you take your pick. The standard pads are soft velour with Velcro attachments on the underside. The MOMO pads are similar, only with more of a cotton fabric - rather than the velour, and they say MOMO on them!
Harness Bars
This Type 305 stainless steel bar attaches to factory mounting points in "B" pillars. Support rods attach to lap belt mounting points. Bar is designed to allow enough seat travel for tall drivers.
Brey-Krause Harness Mount Bar
Brey-Krause harness bars not only guide the driving harnesses, but allow them to be mounted directly to the bar. Their bars are easy to install and remove, use only existing holes and mounting points, and will not damage the car in any way.


In response to the many requests from Porsche drivers looking for a harness guide bar that would not only guide their driving harnesses, but also allow them to mount their harnesses directly to the bar, we developed the "Harness Truss". The Harness Truss has been tested and certified to handle the types of forces required by the National Highway Traffic Safety Admin. DOT and SAE J385 Rev.MAR 95, Motor Vehicle Seat Belt Anchorages-Performance Requirements. It's strong, yet it weighs only a fraction of what a support of the same strength made from tubular or bar steel would weigh. The Harness Truss is precision water-jet machined for a perfect fit into Porsche factory mounting points. This type of machining is accurate and does not create heat effected areas in the metal which can alter tensile strength.

Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. A mount really can't be relied on unless it has been tested to support the loads required by the National Highway Traffic Safety Administration.

Material: 6061-T6 aluminum skeleton and reinforcing bar. Type 304 stainless steel brackets.
Finish: Anodized aluminum with satin stainless mounting brackets.
Weight: 9.44 lbs.
Models: 911 Coupes '74 - '98
Installation: Bar attaches to factory mounting points in "B" pillars.
Miscellaneous: Harness Truss is designed to allow enough seat travel for tall drivers. The stainless steel mounting brackets can be left installed in the "B" pillars to easily remove and remount the bar in minutes. R-9018 Adapter Bracket - is available to attach Brey-Krause seat brace
Models: R-9019 or R-9020.
Porsche Home  >  Porsche 911 (1989-1998) > Interior  >  Seats, Belts & Upholstery 

  Page 1 of 2  12>



  Search our site:    
   Cart  | Project List | Order Status | Help    
 

[Home] [Customer Service] [Shopping Cart] [Project/Wish List]
  [Privacy Statement]  [Contact Us] [About Us] [Shipping]

Copyright 2012, Pelican Parts Inc. -    DMCA Registered Agent Contact Page

Page last updated: Wed 1/27/2016 05:58:18 AM