Pelican Parts
BMW Parts Catalog Accessories Catalog BMW How To Articles BMW Tech Forums
Call Pelican Parts at 888-280-7799
1997 BMW 328is Base Coupe
 
 
Tool Catalog
Toolkits & Tools - Factory
Floor Jacks
Jack Pads
AC Hydraulic Jacks
Hydraulic Jack Oil
Jack Stands
Tool Boxes & Trays
Creepers
Wrenches
Fan Clutch Wrenches
Torque Wrenches
Torque Wrench Inserts
Bit Sets
Screwdrivers
Sockets
Pliers
Hammers and Mallets
Diagonal Cutters
Center Cutters
Cable Cutters
Bolt Cutters
Pry Bars
Breaker Bars
Snips and Cutting Tools
Chisels
Rivet Tools
Work Lights
Flashlights
Vises
Jump Starter
Code Scan / Reset
Peake Research Code Scan
Peake Research SRS Reset
Diagnostic Scanners
AutoEnginuity ScanTool Kits
ScanTool Software Expansions
Break Out Boxes
Electronic Diagnostic Tools
Air/Fuel Ratio Meters
WEGO IV Air/Fuel Tuning
K&N Air/Fuel Monitor
Jack Pads
Lug Nut Sockets
Clutch Alignment Tools
Clutch Tools
Engine Stands
Engine Tools
Valve Spring Compressors
Valve Keeper Tools
Flywheel Locks
Leakdown Testers
Compression Testers
Oil System Tools
Timing Chain Tools
Timing Lights
Pulley Tools
Cylinder Head Tools
Piston Ring Compressors
Camshaft Tools
Cam Timing Tools
Stud Removal Tools
Spark Plug Tools
Oil Filter Tools
Oil Drain Pans
Drain Plug Tools
Dial Indicators
Gasket Remover
Cooling System Tools
Oxygen Sensor Removal
Suspension Tools
Wheel Bearing Puller
Spring Compressors
Ball Joint Tools
Bearing Tools
Control Arm Tools
Alignment Tools
Smart Racing Alignment Tools
Grease
Lubricants
Strut Mount Tools
Emergency Bumper Set
Axle Shaft Tools
Transmission Tools
Transmission Drain Plug Tools
Panel Removal Tools
Brake Tools
Caliper Tools
Brake Fluid Testers
Brake Bleeder Valves
Speed Bleeders
Power Bleeder
Brake Bleeding
Mirrors and Magnets
Thermometers
Dashboard Tools
Disassembly Tools
Radio Removal Tools
Airbag Tools
Pullers
Hose Removal Tools
Anti-Seize Products
Assembly Paste
Service Covers
Mats
Safety Glasses
Ear Protection
Latex and Nitrile Gloves
Work Gloves
Respirators & Masks
Media Blaster Machine
Parts Cleaners
Hand Cleaner
Hand Wipes
Towels and Rags
Multimeters
Refractometers
Electrical Wiring Tools
Soldering
Electrical Tape
Heat Shrink Tubing
Heat Guns
Wire Connectors
Air Blow Guns
Spray Bottles
BMW Home > 1997 BMW 328is Base Coupe > Tools & BooksTools  

Tools

- Page 16

Rear Wheel Bearing Extractor and Installer Kit
If you want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one master kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze. The tool eliminates the need for such drastic measures such as a slide hammer or flame torch to remove the rear wheel bearing. The tool facilitates the installation and removal of the rear bearings, and makes the whole job 1000% easier.

Spring Compressors
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: Includes three sets of jaws for 110, 120, and 130 mm springs, For Mercedes 163, 164, 171, 219, 230, and 251 chassis cars.

Baum Tools
Brand Rating
$701.50
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For Mercedes 116, 123, 124, 126, 129, 140, 170, 201, 202, 208, 210, and 211 chassis cars and BMW E31 chassis rear coil springs, All clearance sales are final; no returns allowed.

Baum Tools
Brand Rating
$902.75
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For removal and installation of the rear coil springs on BMW E70, E90, E91, E92, and E93 chassis.

Baum Tools
Brand Rating
$646.25
Ball Joint Installation Tools
Ball Joint Tool Kit  
 
[ More Info ]

Note: Used to remove and install the front lower outer ball joint in the control arm. For BMW chassis E30 and E36,

Baum Tools
Brand Rating
$327.75

Ball Joint Tool Kit  
 
[ More Info ]

Note: Used to remove and install the front lower inner ball joint in the control arm. For BMW chassis E30 and E36, All clearance sales are final; no returns allowed.

Baum Tools
Brand Rating
$315.00

Mueller-Kueps' Press and Pull Sleeve kit is a universal tool set for extracting and mounting the following: Silent bearings, hydraulic bearings, ball bearings, rubber bearings, shaft seals, bearing bushes, etc.
Ideal for various vehicles, due to universal application.
Sleeves inner diameter from 34 - 72 mm

Designed for the proper disassembly of the pitman arm type tie rod ends w/o tearing the ball joint boots.

Designed for the proper disassembly of ball joints on drag links and tie rods. Base of opening is 21.5mm

Designed for the proper disassembly of ball joints from lower wishbone. Base of opening is 25.5mm
Bearing Tools
Bearing Mount Stick - Loctite Bearing Mount Stick (9 g. Stick)  
 
[ More Info ]

Note: Used to bond non-threaded cylindrical metal assemblies. Replaces clamp rings, set screws, and snap rings.

Loctite
Brand Rating
$13.00

The B90K is a press kit that removes and installs front and rear wheel bearing with the spindle on the car.

BMW Home  >  1997 BMW 328is Base Coupe > Tools & Books  >  Tools  

  Page 16 of 27  <1.. 1415161718.. 27>


Browse Tools for all 3-Series E36 (1992-1999) vehicles

Page last updated: Wed 12/13/2017 03:08:30 AM
QUICK LINKS
About Us
Careers
Pelican Parts, LLC
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
888-280-7799
CONNECT WITH US
NEWSLETTER
Sign Up for Pelican Pit Stop News & Special Offers

Close this window