Pelican Parts
BMW Parts Catalog Accessories Catalog BMW How To Articles BMW Tech Forums
Call Pelican Parts at 888-280-7799
2005 BMW 325xi Base Wagon
 
 
Tool Catalog
Toolkits & Tools - Factory
Floor Jacks
Jack Pads
AC Hydraulic Jacks
Hydraulic Jack Oil
Jack Stands
OEM Tool Kit
OEM Tools
Tool Boxes & Trays
Creepers
Wrenches
Fan Clutch Wrenches
Torque Wrenches
Torque Wrench Inserts
Bit Sets
Screwdrivers
Sockets
Pliers
Hammers and Mallets
Diagonal Cutters
Center Cutters
Cable Cutters
Bolt Cutters
Pry Bars
Breaker Bars
Snips and Cutting Tools
Chisels
Rivet Tools
Work Lights
Flashlights
Vises
Jump Starter
Code Scan / Reset
Peake Research Code Scan
Peake Research SRS Reset
Diagnostic Scanners
AutoEnginuity ScanTool Kits
ScanTool Software Expansions
Break Out Boxes
Electronic Diagnostic Tools
Air/Fuel Ratio Meters
WEGO IV Air/Fuel Tuning
K&N Air/Fuel Monitor
Jack Pads
Lug Nut Sockets
Clutch Alignment Tools
Clutch Tools
Engine Stands
Engine Tools
Valve Spring Compressors
Valve Keeper Tools
Flywheel Locks
Leakdown Testers
Compression Testers
Oil System Tools
Timing Chain Tools
Timing Lights
Pulley Tools
Cylinder Head Tools
Piston Ring Compressors
Crankshaft Tools
Camshaft Tools
Cam Timing Tools
Stud Removal Tools
Spark Plug Tools
Oil Filter Tools
Oil Drain Pans
Drain Plug Tools
Dial Indicators
Gasket Remover
Cooling System Tools
Oxygen Sensor Removal
Suspension Tools
Wheel Bearing Puller
Spring Compressors
Ball Joint Tools
Bearing Tools
Mount Puller Tools
Control Arm Tools
Alignment Tools
Smart Racing Alignment Tools
Grease
Lubricants
Strut Mount Tools
Emergency Bumper Set
Axle Shaft Tools
Transmission Tools
Transmission Drain Plug Tools
Panel Removal Tools
Brake Tools
Caliper Tools
Brake Fluid Testers
Brake Bleeder Valves
Power Bleeder
Brake Bleeding
Mirrors and Magnets
Thermometers
Dashboard Tools
Disassembly Tools
Radio Removal Tools
Airbag Tools
Pullers
Hose Removal Tools
Anti-Seize Products
Assembly Paste
Service Covers
Mats
Safety Glasses
Ear Protection
Latex and Nitrile Gloves
Work Gloves
Respirators & Masks
Media Blaster Machine
Parts Cleaners
Hand Cleaner
Hand Wipes
Towels and Rags
Multimeters
Refractometers
Electrical Wiring Tools
Soldering
Electrical Tape
Heat Shrink Tubing
Heat Guns
Wire Connectors
Air Blow Guns
Spray Bottles
BMW Home > 2005 BMW 325xi Base Wagon > Tools & BooksTools  

Tools

- Page 11

WEGO IV Wide-Band Air/Fuel Ratio Tuning Aid
The WEGO IV is a highly accurate and complete air/fuel ratio metering system with built-in data logging. The unit displays air/fuel ratio (AFR) and continuously logs over 2 hours of data, including AFR, engine RPM, and a spare 0-5V analog input for sensors such as throttle position or manifold pressure.
  • Includes Bosch LSU 4.2 oxygen sensor, 96" sensor extension cable, 18 x 1.5 mm weld nut for exhaust pipe, USB cable, and software for downloading and charting
  • Data is easily exported to a spreadsheet
  • Attractive black anodized aluminum housing with convenient front panel mini USB port, compact size: 3.3"L x 2.1"W x 0.9"H
  • RPM input signal connects directly to Porsche tachometer - no adapter required
  • Easy free-air calibration for sensor aging effects
  • Ultra-bright daylight readable blue LED display and automatic dimming under low light conditions
  • 0-5V analog AFR output for interface to dyno instrumentation
  • Industrial grade clamping terminal block on rear panel allows easy hookup
Available in either single or dual channel. Dual channel unit displays and logs two channels of AFR data. The 12 foot extension cable is sold separately and is necessary for installation in a rear engine car (two are required for the dual-channel unit).

K&N Air/Fuel Monitor
The K&N Air/Fuel Monitor is designed to help the performance enthusiast calibrate and fine tune the air/fuel mixture ratio. It is an invaluable diagnostic tool that has a place in everyone's tool box, or you can install it in your car to give you real-time readings. This kit continually monitors an engine's air/fuel ratio while the engine is running. It is extremely sensitive to air/fuel ratio changes and will show them instantly and accurately, within the range of the oxygen sensor.

The instrument works whether the engine is carbureted or fuel injected, normally aspirated, turbocharged, or supercharged, and at any load condition. This precision instrument also works with nitrous oxide, but will not work with diesel or nitromethane fuels. This kit comes complete with an oxygen sensor that must be installed into the exhaust system by welding. If your car is already equipped with an oxygen sensor an air/fuel monitor may be purchased separately and wired into the existing electrical system. An oxygen sensor is also available separately.

Vehicles with dual exhaust systems can utilize an oxygen sensor in each headpipe or collector that is controlled by a switch that will allow each sensor or bank of cylinders to be read independently. This can show if there is a fuel distribution problem within the intake system, or help to pinpoint a potential problem in advance.

Jack Pads

Due to the unique jack mount points on some cars it can be difficult to safely lift your vehicle with a floor jack without damaging your pride and joy. A Jack Pad is the answer to the problem. Now you never have to worry about damage to your undercarriage again!
Jack Pad - Under Car Support Pad for Lifting Car
Jack Pad - Under Car Support Pad for Lifting Car  
 
[ More Info ]

  (4 per car, sold individually)
Note: All clearance sales are final; no returns allowed.

Genuine BMW
Brand Rating
$23.00



Jack Pad Adapter - Black Anodized Aluminum  
 
[ More Info ]

Note: Designed to fit into the factory under car jack pads, creating a flat circular jack point for a hydraulic floor jack,

Domestic Aftermarket
Brand Rating
$26.25

Lug Nut Sockets

Clutch Alignment Tools

Clutch Tools

Pressure Adaptor needed for pressuring the master cylinder or clutch slave cylinder reservoirs. Used in conjunction with a pressure bleeder. Comes with a 1/4-18 NPT threaded opening. Applicable to most European models.

Designed to extract bearings and bushings with an I.D. of 12mm up to 15mm.

These odd-shaped sockets are required to remove some of the bolts that connect the engine to the transmission. Seven sizes E-6 through E-16. The three smaller sizes are 1/4" drive; the four larger sizes are 3/8" drive. Made of heat-treated alloy steel. Sockets are kept in a convenient vinyl holder. Includes External Torx Sockets: E6, E7, E8, E10, E12, E14, and E16.
BMW Home  >  2005 BMW 325xi Base Wagon > Tools & Books  >  Tools  

  Page 11 of 27  <1.. 910111213.. 27>


Browse Tools for all 3-Series E46 (1999-2006) vehicles

Page last updated: Tue 12/5/2017 11:55:38 PM
QUICK LINKS
About Us
Careers
Pelican Parts, LLC
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
888-280-7799
CONNECT WITH US
NEWSLETTER
Sign Up for Pelican Pit Stop News & Special Offers

Close this window