Pelican Parts
BMW Parts Catalog Accessories Catalog BMW How To Articles BMW Tech Forums
Call Pelican Parts at 888-280-7799
1988 BMW 325i Base Sedan
 
BMW Home > 1988 BMW 325i Base Sedan > Transmission & ClutchClutch & Flywheel  

Clutch & Flywheel

- Page 3

Clutch Hydraulic Hoses and Lines

If your clutch hoses appear swollen or cracked, they may need replacement. Replace your hoses today and keep your car running. Don't take that chance of breaking a clutch hose and being stranded by the side of the road.
Fluid Hose - Clutch Slave Cylinder

Clutch Hose Fitting - Fluid Reservoir Hose to Master Cylinder
UUC Stainless Steel Clutch Lines
UUC's Stainless Clutch Line is used to "performance tune" your clutch control. Inner Teflon line is covered with woven stainless steel braid that will not expand under pressure.
The original clutch line is rubber and can expand under the normal pressure of use. This expansion of the line negatively affects the clutch slave cylinder actuation, and makes for mushy pedal feedback. The advantages of a stainless steel line include better clutch pedal feedback and superior clutch modulation. Results will be immediate.
    Technical features:
  • Line material fully compliant with DOT standards (MVSS-1006)
  • Lines burst-tested to 6000psi (maximum tested pressure from a BMW hydraulic system is 1200psi)
  • Teflon inner line covered with a woven layer of stainless steel and covered in an abrasion-resistant material (translucent blue plastic covering)
  • End pieces perfectly match original BMW design for easy assembly

Clutch Master Cylinders and Parts

Is your clutch release not working as well as you'd like it to? Are you a slave to your worn out cylinders? Get control with a replacement master or slave clutch cylinder. Replacing the slave cylinder is a good idea when you are performing a clutch job. With a relatively low cost, the insurance of replacing it when you're performing a big clutch job is well worth the cost. The way a hydraulic clutch works is quite simple to understand. When you push the clutch pedal, it sends fluid from the clutch master cylinder down a hose to the clutch slave cylinder, which is mounted on the transmission. The fluid, which is under pressure, forces the clutch cylinder to push out a rod, which is connected mechanically to the release fork. When the rod moves, it also moves the release fork, disengaging the clutch, and allowing you to shift. Also be sure to purge the system of air bubbles at the same time.
Clutch Master Cylinder
Clutch Master Cylinder  
 
[ More Info ]

Note: May req 1x 21 52 1 151 697 Connector

Sanyco
Brand Rating
$52.75


Clutch Pivot Balls

Your pivot balls should always be checked when working on your clutch. If you need new ones Pelican has them.
Pivot Pin - Clutch Release Fork Lever

Clutch Release Arms and Parts

The clutch release arm assists in the release of pressure from the pressure plate on the clutch disk. It should be checked for cracks, wear or bending and should be replaced when doing a clutch replacement.
Fork Lever - Clutch Release Bearing

BMW Home  >  1988 BMW 325i Base Sedan > Transmission & Clutch  >  Clutch & Flywheel  

  Page 3 of 4  <1234>


Browse Clutch & Flywheel for all 3-Series E30 (1983-1991) vehicles

Page last updated: Mon 11/13/2017 2:13:02 PM
QUICK LINKS
About Us
Careers
Pelican Parts, Inc.
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
888-280-7799
CONNECT WITH US
NEWSLETTER
Sign Up for Pelican Pit Stop News & Special Offers

Close this window