Pelican Parts
BMW Parts Catalog Accessories Catalog BMW How To Articles BMW Tech Forums
Call Pelican Parts at 888-280-7799
1987 BMW 325e Base Coupe
 
 
Tool Catalog
Toolkits & Tools - Factory
Floor Jacks
Jack Pads
AC Hydraulic Jacks
Hydraulic Jack Oil
Jack Stands
Tool Boxes & Trays
Creepers
Wrenches
Fan Clutch Wrenches
Torque Wrenches
Torque Wrench Inserts
Bit Sets
Screwdrivers
Sockets
Pliers
Hammers and Mallets
Diagonal Cutters
Center Cutters
Cable Cutters
Bolt Cutters
Pry Bars
Breaker Bars
Snips and Cutting Tools
Chisels
Rivet Tools
Work Lights
Flashlights
Vises
Jump Starter
Code Scan / Reset
Peake Research Code Scan
Peake Research SRS Reset
Diagnostic Scanners
Electronic Diagnostic Tools
Air/Fuel Ratio Meters
WEGO IV Air/Fuel Tuning
K&N Air/Fuel Monitor
Lug Nut Sockets
Clutch Tools
Engine Stands
Valve Adjustment Tools
Engine Tools
Valve Spring Compressors
Leakdown Testers
Compression Testers
Oil System Tools
Timing Chain Tools
Timing Lights
Pulley Tools
Cylinder Head Tools
Piston Ring Compressors
Camshaft Tools
Stud Removal Tools
Spark Plug Tools
Oil Filter Tools
Oil Drain Pans
Drain Plug Tools
Dial Indicators
Gasket Remover
Cooling System Tools
Oxygen Sensor Removal
Suspension Tools
Spring Compressors
Ball Joint Tools
Bearing Tools
Shock Absorber Tools
Alignment Tools
Smart Racing Alignment Tools
Grease
Lubricants
Strut Mount Tools
Emergency Bumper Set
Axle Shaft Tools
Transmission Tools
Transmission Drain Plug Tools
Panel Removal Tools
Brake Tools
Caliper Tools
Brake Fluid Testers
Brake Bleeder Valves
Speed Bleeders
Power Bleeder
Brake Bleeding
Mirrors and Magnets
Thermometers
Dashboard Tools
Disassembly Tools
Radio Removal Tools
Wheel Tools
Pullers
Hose Removal Tools
Anti-Seize Products
Assembly Paste
Service Covers
Mats
Safety Glasses
Ear Protection
Latex and Nitrile Gloves
Work Gloves
Respirators & Masks
Media Blaster Machine
Parts Cleaners
Hand Cleaner
Hand Wipes
Towels and Rags
Multimeters
Refractometers
Electrical Wiring Tools
Soldering
Electrical Tape
Heat Shrink Tubing
Heat Guns
Wire Connectors
Air Blow Guns
Spray Bottles
BMW Home > 1987 BMW 325e Base Coupe > Tools & BooksTools  

Tools

- Page 14

Cooling System Tools

Water Pump Holder Tool  
[ More Info ]

Note: Used to hold the water pump hub during removal and installation of the fan clutch on BMW and Land Rover engines,

Assenmacher Tools (AST)
Brand Rating
$85.75

Bleeder tank, Pump, and 2ft. of hose and female brass fitting. Includes everything except the cap so you can customize your own kit for different setups or vehicles.

Oxygen Sensor Removal Tools

Are you having trouble removing the oxygen sensor? Many times, it is not possible to get a wrench or socket around the sensor due to its location in the exhaust. Once again, Pelican has your answer. This special tool allows you to remove the oxygen sensor using a standard 3/8" drive ratchet, simplifying an otherwise difficult job.

Suspension Tools


Designed for the proper removal and installation of the inner ball joints. Used in conjunction with a hydraulic press, or on the car application when used in conjunction with a C-Clamp.

Designed for the proper removal and installation of the outer ball joints. Comes complete with all the components to perfectly mate up to the factory ball joints. Must be used in conjunction with a hydraulic press.

Spring Compressors
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For Mercedes 163, 164, 171, 219, 230, and 251 chassis cars, Includes three sets of jaws for 110, 120, and 130 mm springs.

Baum Tools
Brand Rating
$635.25
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For Mercedes 116, 123, 124, 126, 129, 140, 170, 201, 202, 208, 210, and 211 chassis cars and BMW E31 chassis rear coil springs.

Baum Tools
Brand Rating
$902.75

Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For removal and installation of the rear coil springs on BMW E70, E90, E91, E92, and E93 chassis.

Baum Tools
Brand Rating
$646.25
Ball Joint Installation Tools
Ball Joint Tool Kit  
 
[ More Info ]

Note: Used to remove and install the front lower outer ball joint in the control arm. For BMW chassis E30 and E36,

Baum Tools
Brand Rating
$327.75

Ball Joint Tool Kit  
 
[ More Info ]

Note: Used to remove and install the front lower inner ball joint in the control arm. For BMW chassis E30 and E36,

Baum Tools
Brand Rating
$390.25

Mueller-Kueps' Press and Pull Sleeve kit is a universal tool set for extracting and mounting the following: Silent bearings, hydraulic bearings, ball bearings, rubber bearings, shaft seals, bearing bushes, etc.
Ideal for various vehicles, due to universal application.
Sleeves inner diameter from 34 - 72 mm

Designed for the proper disassembly of the pitman arm type tie rod ends w/o tearing the ball joint boots.

Designed for the proper disassembly of ball joints on drag links and tie rods. Base of opening is 21.5mm

Designed for the proper disassembly of ball joints from lower wishbone. Base of opening is 25.5mm
BMW Home  >  1987 BMW 325e Base Coupe > Tools & Books  >  Tools  

  Page 14 of 25  <1.. 1213141516.. 25>


Browse Tools for all 3-Series E30 (1983-1991) vehicles

Page last updated: Wed 8/16/2017 01:49:53 AM
QUICK LINKS
About Us
Careers
Pelican Parts, Inc.
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
888-280-7799
CONNECT WITH US
NEWSLETTER
Sign Up for Pelican Pit Stop News & Special Offers

Close this window