Pelican Parts
BMW Parts Catalog Accessories Catalog BMW How To Articles BMW Tech Forums
Call Pelican Parts at 888-280-7799
2004 BMW 325Ci Base Coupe
 
 
Tool Catalog
Toolkits & Tools - Factory
Floor Jacks
Jack Pads
AC Hydraulic Jacks
Hydraulic Jack Oil
Jack Stands
OEM Tool Kit
OEM Tools
Tool Boxes & Trays
Creepers
Wrenches
Fan Clutch Wrenches
Torque Wrenches
Torque Wrench Inserts
Bit Sets
Screwdrivers
Sockets
Pliers
Hammers and Mallets
Diagonal Cutters
Center Cutters
Cable Cutters
Bolt Cutters
Pry Bars
Breaker Bars
Snips and Cutting Tools
Chisels
Rivet Tools
Work Lights
Flashlights
Vises
Jump Starter
Code Scan / Reset
Peake Research Code Scan
Peake Research SRS Reset
Diagnostic Scanners
AutoEnginuity ScanTool Kits
ScanTool Software Expansions
Break Out Boxes
Electronic Diagnostic Tools
Air/Fuel Ratio Meters
WEGO IV Air/Fuel Tuning
K&N Air/Fuel Monitor
Jack Pads
Lug Nut Sockets
Clutch Alignment Tools
Clutch Tools
Engine Stands
Engine Tools
Valve Spring Compressors
Valve Keeper Tools
Flywheel Locks
Leakdown Testers
Compression Testers
Oil System Tools
Timing Chain Tools
Timing Lights
Pulley Tools
Cylinder Head Tools
Piston Ring Compressors
Crankshaft Tools
Camshaft Tools
Cam Timing Tools
Stud Removal Tools
Spark Plug Tools
Oil Filter Tools
Oil Drain Pans
Drain Plug Tools
Dial Indicators
Gasket Remover
Cooling System Tools
Oxygen Sensor Removal
Suspension Tools
Wheel Bearing Puller
Spring Compressors
Ball Joint Tools
Bearing Tools
Mount Puller Tools
Control Arm Tools
Alignment Tools
Smart Racing Alignment Tools
Grease
Lubricants
Strut Mount Tools
Emergency Bumper Set
Axle Shaft Tools
Transmission Tools
Transmission Drain Plug Tools
Panel Removal Tools
Brake Tools
Caliper Tools
Brake Fluid Testers
Brake Bleeder Valves
Power Bleeder
Brake Bleeding
Mirrors and Magnets
Thermometers
Dashboard Tools
Disassembly Tools
Radio Removal Tools
Airbag Tools
Pullers
Hose Removal Tools
Anti-Seize Products
Assembly Paste
Service Covers
Mats
Safety Glasses
Ear Protection
Latex and Nitrile Gloves
Work Gloves
Respirators & Masks
Media Blaster Machine
Parts Cleaners
Hand Cleaner
Hand Wipes
Towels and Rags
Multimeters
Refractometers
Electrical Wiring Tools
Soldering
Electrical Tape
Heat Shrink Tubing
Heat Guns
Wire Connectors
Air Blow Guns
Spray Bottles
BMW Home > 2004 BMW 325Ci Base Coupe > Tools & BooksTools  

Tools

- Page 16

Oxygen Sensor Removal Tools

Are you having trouble removing the oxygen sensor? Many times, it is not possible to get a wrench or socket around the sensor due to its location in the exhaust. Once again, Pelican has your answer. This special tool allows you to remove the oxygen sensor using a standard 3/8" drive ratchet, simplifying an otherwise difficult job.

Suspension Tools



Combines 3 OE Tools for On the Car Removal and Installation of the 3 Bushings Located in the Main Rear Trailing Arms. Includes Case. (See below for Specific Bushings and Models)

Bushing (A) 33-32-6-771-828 Lower, outer Bushing
Bushing (B) 33-32-6-770-786 Front of Trailing Arm
Bushing (C) 33-32-6-775-551 Upper, outer Bushing
Rear Wheel Bearing Extractor and Installer Kit
If you want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one master kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze. The tool eliminates the need for such drastic measures such as a slide hammer or flame torch to remove the rear wheel bearing. The tool facilitates the installation and removal of the rear bearings, and makes the whole job 1000% easier.
Spring Compressors
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: Includes three sets of jaws for 110, 120, and 130 mm springs, For Mercedes 163, 164, 171, 219, 230, and 251 chassis cars.

Baum Tools
Brand Rating
$701.50
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For Mercedes 116, 123, 124, 126, 129, 140, 170, 201, 202, 208, 210, and 211 chassis cars and BMW E31 chassis rear coil springs.

Baum Tools
Brand Rating
$902.75
Coil Spring Compressor Tool Kit  
 
[ More Info ]

Note: For removal and installation of the rear coil springs on BMW E70, E90, E91, E92, and E93 chassis.

Baum Tools
Brand Rating
$646.25
Ball Joint Installation Tools
Mueller-Kueps' Press and Pull Sleeve kit is a universal tool set for extracting and mounting the following: Silent bearings, hydraulic bearings, ball bearings, rubber bearings, shaft seals, bearing bushes, etc.
Ideal for various vehicles, due to universal application.
Sleeves inner diameter from 34 - 72 mm

Designed for the proper disassembly of the pitman arm type tie rod ends w/o tearing the ball joint boots.

Designed for the proper disassembly of ball joints on drag links and tie rods. Base of opening is 21.5mm

Designed for the proper disassembly of ball joints from lower wishbone. Base of opening is 25.5mm
BMW Home  >  2004 BMW 325Ci Base Coupe > Tools & Books  >  Tools  

  Page 16 of 27  <1.. 1415161718.. 27>


Browse Tools for all 3-Series E46 (1999-2006) vehicles

Page last updated: Mon 11/13/2017 12:21:02 PM
QUICK LINKS
About Us
Careers
Pelican Parts, Inc.
1600 240th Street
Harbor City, CA 90710
Order Online or Call:
888-280-7799
CONNECT WITH US
NEWSLETTER
Sign Up for Pelican Pit Stop News & Special Offers

Close this window