| BMW E36 Suspension Wizard - Page 3 |
Suspension Tools & Books |
| Separator |
| Designed for the proper disassembly of the pitman arm type tie rod ends w/o tearing the ball joint boots. |
|
PEL-TOL-266H | Separator, BMW All [Photo] | $48.00 |  |
| Heavy Duty Separator |
| Designed for the proper disassembly of ball joints on drag links and tie rods. Base of opening is 21.5mm |
|
PEL-TOL-3029 | Heavy Duty Separator, BMW All [Photo] | $77.70 | |
| Heavy Duty Extractor |
| Designed for the proper disassembly of ball joints from lower wishbone. Base of opening is 25.5mm |
|
PEL-TOL-3030 | Heavy Duty Separator, BMW All [Photo] | $95.80 | |
| Front Wheel Hub/Bearing Nut Socket |
83-30-0-491-896-BOE | Front Wheel Hub/Bearing Nut Socket - 46mm, 3/4 in. Drive, BMW Tool #31-2-080, fits E23, E24, E28, E32, E34, E36, E38, E46 [Photo] | $64.50 | |
| Pin Wrench Socket |
| Needed for R&R of the threaded ring retaining nut on the strut tower/shock absorber. |
|
PEL-TOL-3014 | Pin Wrench Socket, BMW All [Photo] | No Longer Available | |
| Coil Spring Compressor |
| Needed for R&R of coil springs on Macpherson strut type assemblies. This unit incorporates safety retaining pins to completely grab hold of the coils ensuring a No Slip Grip! |
|
PEL-TOL-MP100 | Coil Spring Compressor, BMW All [Photo] | No Longer Available | |
| Rear Wheel Bearing Extractor and Installer Kit |
| If you want to save on a costly repair, replace your own bearing or pull your own hubs with our all in one master kit. Designed to efficiently remove and install hub and wheel bearings, this kit will make the notoriously difficult job of removing rear wheel bearings a breeze. The tool eliminates the need for such drastic measures such as a slide hammer or flame torch to remove the rear wheel bearing. The tool facilitates the installation and removal of the rear bearings, and makes the whole job 1000% easier. |
|
| PEL-TOL-SIRB90-B1 E36 Models: 318ti All
318i, is, ic THRU 11/97 ONLY with Original Trailing arms
323is, ic THRU 11/97 ONLY with Original Trailing arms
325i, is, ic Models with Original Trailing arms
328i, is, ic THRU 11/97 ONLY with Original Trailing arms
|
|
| PEL-TOL-SIRB90-B1 | Hub/Bearing Extractor and Installer Kit | $229.00 | |
| PEL-TOL-SIRB90-B2 E36 Models: 318i, is, ic FROM 12/97 Or Earlier Models with Replacement Trailing Arms
323is, ic FROM 12/97 Or Earlier Models with Replacement Trailing Arms
325i, is, ic Models with Replacement Trailing Arms
328i, is, ic FROM 12/97 Or Earlier Models with Replacement Trailing Arms
|
|
| PEL-TOL-SIRB90-B2 | Hub/Bearing Extractor and Installer Kit | $232.00 | |
| PEL-TOL-SIRB90-M3 E36 M3 (1995-99)
|
|
| PEL-TOL-SIRB90-M3 | Hub/Bearing Extractor and Installer Kit | Temporarily unavailable | |
