| BMW E30 Specialty Tools - Page 6 |
Cooling System Tools |
| You can't do a job right without the correct tools. We here at Pelican are proud to offer these special tools for the BMW E30 cooling system. |
|
| Counter Holders |
| These counter holders are a necessity for removing the water pump from your BMW they are used to secure the fan hub While you remove the fan clutch pulley nut. |
|
PEL-TOL-3037 | Counter Holder, 318i/is/iC (1991) [Photo] | $32.30 |  |
PEL-TOL-3008 | Counter Holder, BMW E30 3 Series, All except 318i/is/iC (1991) [Photo] | $36.50 | |
| Fan Clutch Wrench |
| This special wrench is used in conjunction with the counter holder to remove the reverse threaded nut on the fan clutch pulley. |
|
PEL-TOL-1032T | Fan Clutch Long Thin Spanner Wrench (32mm open end, 8mm thickness), BMW All Models, Each [Photo] | $34.00 | |
Transmission Tools |
| Transmission Bearing Extractors |
| These bearing extractors are used to pull bearings out of the BMW transmission when doing a rebuild. |
|
PEL-TOL-242 | Transmission Bearing Extractor Master Kit (contains all extractors listed below), Each [Photo] | $566.10 | |
| PEL-TOL-242A | Transmission Bearing Extractor, For 44.50 to 41.50mm sized bearings, Each | $68.80 | |
| PEL-TOL-242B | Transmission Bearing Extractor, For 37 to 35mm sized bearings, Each | $68.80 | |
| PEL-TOL-242C | Transmission Bearing Extractor, For 41.50 to 38.50mm sized bearings, Each | $68.80 | |
| PEL-TOL-242E | Transmission Bearing Extractor, For 40.50 to 38.50mm sized bearings, Each | $68.80 | |
| PEL-TOL-242F | Transmission Bearing Extractor, For 42.50 to 40.50mm sized bearings, Each | $68.80 | |
| PEL-TOL-242G | Transmission Bearing Extractor, For 43.50 to 41mm sized bearings, Each | $68.80 | |
| PEL-TOL-242H | Transmission Bearing Extractor, For 32 to 30mm sized bearings, Each | $68.80 | |
| PEL-TOL-242I | Transmission Bearing Extractor, For 48 to 45.50mm sized bearings, Each | $68.80 | |
| 30mm Flange Nut Socket |
| This special 30mm deep walled socket is used to remove both the drive shaft flange nuts and the pinion drive shaft nuts on the differential. |
|
PEL-TOL-3025 | 30mm Flange Nut Socket, BMW All Models, Each [Photo] | $40.40 | |
| Transmission Drain Plug Socket |
| This special 17mm ID socket is used to remove the transmission fill and drain plugs. This tool is essential when doing any transmission service. Please be sure to check first if your transmission uses this type of plug before ordering. |
|
PEL-DPR-1017 | Transmission Drain Plug Socket, BMW All Models with 17mm allen plugs, Each [Photo] | $25.00 | |
