| BMW E30 Suspension Tools & Books - Page 2 |
Suspension Tools |
| Bushing Master Kit |
| No need to disassemble the whole rear end in order to use a hydraulic press with this tool. Designed for "On the Car Application" . This kit is needed for the proper R&R of the metal-clad rubber mount bushings of the rear Axle carrier sub frame. Incorporating a thrust bearing to ease the pulling/pushing action, reduces the wear and tear of the tool, ensuring longevity. This Bushing Master Kit comes complete with all the proper components to efficiently get the job done right. Comes equipped with a 14mm threaded rod and press nut. |
|
PEL-TOL-3026 | Rear Sub-frame Bushing Master Kit, BMW Chassis E23, E24, E28, E30, E32, E34, E36 [Photo] | $373.60 |  |
| Press Arbor Kit/Outer Ball Joint |
| Designed for the proper removal and installation of the outer ball joints. Comes complete with all the components to perfectly mate up to the factory ball joints. Must be used in conjunction with a hydraulic press. |
|
PEL-TOL-3038 | Press Arbor Kit, BMW E30 3 Series [Photo] | $161.10 | |
| Press Arbor Kit/Inner Ball Joint |
| Designed for the proper removal and installation of the Inner ball joints. Used in conjunction with a hydraulic press, Or on the car application when used in conjunction with a C-Clamp. |
|
PEL-TOL-3028 | Press Arbor Kit, BMW E30 and E36 3 Series [Photo] | $141.70 | |
| Separator |
| Designed for the proper disassembly of the pitman arm type tie rod ends w/o tearing the ball joint boots. |
|
PEL-TOL-266H | Separator, BMW All [Photo] | $48.00 | |
| Heavy Duty Separator |
| Designed for the proper disassembly of ball joints on drag links and tie rods. Base of opening is 21.5mm |
|
PEL-TOL-3029 | Heavy Duty Separator, BMW All [Photo] | $77.70 | |
| Heavy Duty Extractor |
| Designed for the proper disassembly of ball joints from lower wishbone. Base of opening is 25.5mm |
|
PEL-TOL-3030 | Heavy Duty separator, BMW All [Photo] | $95.80 | |
| Pin Wrench Socket |
| Needed for R&R of the threaded ring retaining nut on the strut tower/shock absorber. |
|
PEL-TOL-3014 | Pin Wrench Socket, BMW All [Photo] | No Longer Available | |
| Coil Spring Compressor |
| Needed for R&R of coil springs on Macpherson strut type assemblies. This unit incorporates safety retaining pins to completely grab hold of the coils ensuring a No Slip Grip! |
|
PEL-TOL-MP100 | Coil Spring Compressor, BMW All [Photo] | No Longer Available | |
