| BMW E28 Main Engine Components - Page 2 |
Piston Pin/Connecting Rod Bushings |
| These bushings are used to support and secure the piston pin inside the piston, and hold it to the connecting rod. Always replace these bushings whenever you are doing a rebuild of your engine. |
|
11-24-1-278-209-M41 | Piston Pin/Connecting Rod Bushing (6 per car, sold individually), 528e (1982-88), Each
Brand: Glyco [More Info] |  |
| $5.00 |  |
11-24-0-618-100-M41 | Piston Pin/Connecting Rod Bushing (6 per car, sold individually), 533i (1983-84), 535i/is (1985-88), Each
Brand: Glyco [More Info] | |
| $3.75 | |
Piston Pin Snap Rings  |
| These small snap rings are used to secure the piston pin in place on the connecting rod. Replace them whenever you are rebuilding your engine. It is cheap insurance against massive engine damage. |
|
07-11-9-934-460-BOE | Piston Pin Snap Ring (6 per car, sold individually), All Except 524td and M5, Each
Brand: Genuine BMW [More Info] | $0.75 | |
| 07-11-9-934-463-BOE | Piston Pin Snap Ring (6 per car, sold individually), 524td (1985), Each [More Info] | No Longer Available | |
Engine Seals and Gasket Sets |
| Worried about engine leaks? Is your garage becoming a worthy candidate for an EPA Superfund clean-up project? Seal your engine's fate with our rebuild gasket sets. |
|
| Bottom End Gasket Sets |
11-11-9-063-134-M17 | Engine Gasket Set for Engine Block, 528e (1982-88), Each
Brand: Victor Reinz [More Info] | |
| $35.75 | |
11-11-1-735-046-M17 | Engine Gasket Set for Engine Block, 533i (1983-84), 535i/is (1985-88), M5 (1988), Each
Brand: Victor Reinz [More Info] | |
| $39.25 | |
| Front Main Seals |
| Crankshaft Seal, Front, E28 524td, 528e |
11-14-1-275-466-M30 | Crankshaft Seal, Front, E28 524td, 528e
Brand: Elring Klinger [More Info] | |
| $5.00 | |
11-14-1-275-466-M104 | Crankshaft Seal, Front, E28 524td, 528e
Brand: Corteco-CFW [More Info] | |
| $10.50 | |
| Rear Crankshaft Seal |
11-14-1-432-240-M17 | Gasket, Rear Crankshaft Seal Housing, E28 524td, 528e
Brand: Victor Reinz [More Info] | |
| $1.75 | |
Valve Cover Gaskets |
| These gaskets should be replaced every time that you adjust your valves. |
|
| Valve Cover Gaskets |
11-12-1-285-973-M30 | Valve Cover Gasket, 524td (1985), Each
Brand: Elring Klinger [More Info] | |
| $9.75 | |
11-12-1-730-229-M17 | Valve Cover Gasket (NOTE: This brand has a hard waffle finish with a silicone bead) Also use four 11-33-1-264-519-M17 rocker shaft plugs, 528e (1982-88)
Brand: Victor Reinz [More Info] | |
| $7.25 | |
11-12-1-730-229-M30 | Valve Cover Gasket (NOTE: This brand has a hard waffle finish without a silicone bead) Also use four 11-33-1-264-519-M17 rocker shaft plugs, 528e (1982-88)
Brand: Elring Klinger [More Info] | |
| $12.00 | |
11-12-1-730-229-M42 | Valve Cover Gasket (NOTE: This brand has a soft waxy waffle finish without a silicone bead) Also use four 11-33-1-264-519-M17 rocker shaft plugs, 528e (1982-88)
Brand: Goetze [More Info] | |
| $9.75 | |
11-33-1-264-519-M17 | Rocker Shaft Plug, On Ends Of Cylinder Head (4 per car, sold individually), 528e (1982-88)
Brand: Victor Reinz [More Info] | |
| $1.00 | |
| Valve Cover Gasket, 533i (1983-84), 535i/is (1985-88), Each |
11-12-1-730-231-M17 | Valve Cover Gasket, 533i (1983-84), 535i/is (1985-88), Each
Brand: Victor Reinz [More Info] | |
| $8.50 | |
11-12-1-730-231-M30 | Valve Cover Gasket, 533i (1983-84), 535i/is (1985-88), Each
Brand: Elring Klinger [More Info] | |
| $14.25 | |
|
11-12-1-312-172-M30 | Valve Cover Gasket, M5 (1988), Each
Brand: Elring Klinger [More Info] | |
| $35.00 | |
11-12-1-312-173-M30 | Spark Plug Hole Gasket for Valve Cover (3 per car, sold individually), M5 (1988), As Needed, Each
Brand: Elring Klinger [More Info] | |
| $4.75 | |
