| BMW Z3 3.0i - Axles & Bearings - Page 1 |
| The axle shaft assembly is the direct mechanical link that transfers power from the transaxle to the rear wheels. They are designed to allow the axle to continue transmitting power from the differential to the wheels when moving up and down by means of a flexible link called a constant velocity or CV joint. Over time, the bearings in these joints wear, causing the axle to eventually fail. A faulty bearing can make a grinding or clicking noise, may cause the vehicle to shake while driving, or even prevent the axle from turning at all. |
|
Drive Shaft Flex Disc |
| The flex disc is the connecting piece between the torque converter and the engine. |
|
26-11-7-511-454-M57 | Flex Disc Output Flange to Driveshaft 96 mm Diameter 12 mm Bolt Holes, Z3 3.0i Auto & Manual Trans
Brand: OEM [Photo] |  |
| $54.50 |  |
Driveshaft Center Support |
| The driveshaft support is used to hold and support the driveshaft from the transmission to the differential. |
|
26-12-1-229-089-M69 | Center Support with Bearing Assembly for Driveshaft, Z3 3.0i Manual Transmission
Brand: Lemfoerder [Photo] | |
| $61.25 | |
Driveshaft Clamping Ring |
26-11-7-514-037-M9 | Clamping Ring with Threaded Ring for Drive Shaft, Z3 3.0
Brand: Genuine BMW [Photo] | |
| $14.50 | |
Driveshaft End Bushing |
| Bushing used to center the driveshaft inside the driveshaft support assembly. |
|
26-11-7-526-611-M104 | Guide Bushing for Drive Shaft (Centering Sleeve), Z3 3.0
Brand: CFW-Freudenberg [Photo] | |
| $10.00 | |
Differential Drain Plug |
33-11-7-525-064-M9 | Differential Drain Plug with O-Ring (22 X 1.5 mm), Z3 3.0i
Brand: Genuine BMW [Photo] | |
| $5.25 | |
Differential Cover Gasket |
| The differential cover seal is used to keep gear oil from leaking out of the differential. |
|
33-11-1-211-708-M17 | Gasket for Differential Cover, Z3 3.0
Brand: Victor Reinz [Photo] | |
| $2.50 | |
Differential Lock Plate |
23-21-1-490-120-M9 | Lock Plate for Output Flange Nut on Manual Transmission and Differential Input Flange Nut, Z3 3.0
Brand: Genuine BMW [Photo] | |
| $1.50 | |
Differential O-Ring |
33-11-1-214-144-M213 | O-Ring for Differential Side Covers (2 Per Car) 90 X 3 mm, Z3 3.0
Brand: D P H [Photo] | |
| $2.25 | |
Differential Output Shaft Clip |
33-13-1-207-280-M9 | Output Shaft Clip for Differential, Z3 3.0
Brand: Genuine BMW [Photo] | |
| $0.50 | |
Differential Carrier Bearing |
33-13-1-213-893-M34 | Carrier Bearing for Differential Output Shaft (2 Per Car) 46.0 X 75.0 X 18.0 mm, Z3 3.0
Brand: FAG [Photo] | |
| $17.50 | |
