| BMW Z3 2.8 - Exhaust Pipes - Page 1 |
| There's no mistaking a leaking exhaust system - your neighbors will tell you that. It could be a bad muffler, a broken gasket, or even a missing exhaust hanger. Whatever's causing the racket, you'll find a quality OEM replacement in this section. Or, if you're looking for better flow and enhanced performance, be sure to browse our selection of upgrades as well. |
|
Oxygen Sensor |
| The oxygen sensor measures exhaust gases, then sends a signal to the fuel injection control unit to set the correct fuel air mixture for the engine to run correctly. If the oxygen sensor fails, it can cause rough running and poor fuel economy. |
|
11-78-1-427-884-M209 | Oxygen Sensor Length = 990 mm, Z3 2.8 thru 08/98- (1) after catalyst
Brand: NTK [More Info] |  |
| $99.50 |  |
11-78-1-433-071-M209 | Oxygen Sensor Length = 410 mm, Z3 2.8 thru 08/98- (1) before catalyst
Brand: NTK [More Info] | |
| $104.75 | |
11-78-1-433-940-M14 | Oxygen Sensor Length = 990 mm, Z3 2.8 from 09/98- (2) after catalyst
Brand: Bosch [More Info] | |
| $96.75 | |
11-78-1-742-050-M14 | Oxygen Sensor Length = 320 mm, Z3 2.8 from 09/98- (2) before catalyst
Brand: Bosch [More Info] | |
| $84.00 | |
Actuator - Trunk Lock |
67-11-8-360-732-M82 | | $62.00 | |
Exhaust Stud |
11-12-1-744-057-M9 | Exhaust Port Stud 7 X 42 mm, Z3 2.8i thru 02/00
Brand: Genuine BMW [More Info] | |
| $3.50 | |
Exhaust Gasket |
11-62-1-732-969-M17 | Exhaust Manifold Gasket Between Cylinder Head and Exhaust Manifold (2 Per Car), Z3 2.8 from 09/98
Brand: Victor Reinz [More Info] | |
| $18.50 | |
11-62-1-744-252-M17 | Exhaust Manifold Gasket at Cylinder Head (2 Per Car), Z3 2.8 thru 08/98
Brand: Victor Reinz [More Info] | |
| $7.50 | |
11-72-1-435-367-M17 | Gasket for Air Intake Tube to Exhaust Manifold, Z3 2.8 thru 8/98 (2 Per Car)
Brand: Victor Reinz [More Info] | |
| $4.25 | |
18-30-1-440-183-M213 | Exhaust Gasket Catalytic Converter to Front Muffler and Manifold to Catalytic Converter (2 Per Car), Z3 2.8 from 09/98
Brand: D P H [More Info] | |
| $6.00 | |
| Exhaust Manifold Gasket to Catalyzer Pipe, Z3 2.8i thru 08/98(2 Per Car) |
| 18-30-1-716-888-M17 | Exhaust Manifold Gasket to Catalyzer Pipe, Z3 2.8i thru 08/98(2 Per Car)
Brand: Victor Reinz [More Info] | |
| $5.75 | |
18-30-1-716-888-M131 | Exhaust Manifold Gasket to Catalyzer Pipe, Z3 2.8i thru 08/98(2 Per Car)
Brand: Fischer & Plath [More Info] | |
| $1.00 | |
|
18-21-1-105-635-M737 | Muffler Hanger Reinforced Rubber, Z3 2.8
Brand: [More Info] | |
| $3.50 | |
18-21-1-247-422-M90 | Muffler Hanger Rear Rubber Hanger, Z3 2.8 thru 08/98
Brand: Trucktec [More Info] | |
| $6.00 | |
Exhaust Nut |
| Used to bolt exhaust components together. |
|
11-72-1-437-202-M58 | Copper Collar Nut 7 mm Exhaust Manifold to Cylinder Head, Z3 2.8
Brand: OEM [More Info] | |
| $1.00 | |
18-30-1-737-774-M58 | Copper Lock Nut 10 mm Exhaust Flange, Z3 2.8
Brand: OEM [More Info] | |
| $1.00 | |
