| BMW Z3 1.9 - Intake System - Page 1 |
| From the airbox to the intake manifold, air is routed to the engine at a defined volumetric rate that allows optimum combustion for specific levels of performance. Any alteration or failure within this system can therefore cause drivability problems like hesitation or rough idling. You can try cleaning and sealing these components as much as you want, but more often than not, installing brand new OEM parts is the best cure for these types of problems. |
|
Air Filter |
| It's important to make sure that your air cleaner is clean at all times. The cleaner filters outside air before it enters your engine. Dirty air filters will constrict the air flow, and reduce your overall horsepower and gas mileage. You should replace |
|
| Air Filter, Z3 1.9 |
13-72-1-247-404-M318 | | $56.25 |  |
13-72-1-247-404-M67 | | $13.50 | |
13-72-1-247-404-M63 | | $16.25 | |
Air Filter Housing Clip |
13-71-9-071-752-M9 | Air Filter Housing Clip Used to Hold Top Housing to Bottom Housing, Z3 1.9
Brand: Genuine BMW [More Info] |  |
| $3.50 | |
Rubber Mount |
| Air Cleaner Mount/Buffer |
13-71-1-259-818-M200 | Rubber Mount Air Filter Housing, Z3 1.9 Air Box (2 Per Car)
Brand: MTC [More Info] | |
| $3.00 | |
Air Mass Sensor |
| This meter is part of the fuel injection system and is used to measure the amount of incoming air into the intake manifold. |
|
13-62-1-736-224-M14 | Air Mass Sensor, Z3 1.9 (1 Per Car)
Brand: Bosch [More Info] | |
| $327.25 | |
Engine Air Intake Boot/Hose |
| The Intake Boot is used to connect the intake manifold to the air flow meter. |
|
13-71-1-247-031-M9 | Intake Boot Air Mass Sensor to Throttle Body NOTE: Not for cars with ASC+T, Z3 1.9
Brand: Genuine BMW [More Info] | |
| $33.00 | |
13-71-1-433-979-M9 | Intake Boot From Air Flow Meter to Throttle Body NOTE:For cars with ASC+T, Z3 1.9
Brand: Genuine BMW [More Info] | |
| $33.00 | |
Air Hose Connector |
| The air distribution hose connects air distribution lines together |
|
13-41-1-722-944-M9 | Air Hose Connector Air Hose to Intake Boot, Z3 1.9
Brand: Genuine BMW [More Info] | |
| $1.25 | |
Intake Manifold Gasket |
| The intake manifold gaskets used to seal the intake manifold to the cylinder head. |
|
11-61-1-247-478-M17 | Intake Manifold Gasket Gasket Between Upper and Lower Manifolds (2 Per Car), Z3 1.9
Brand: Victor Reinz [More Info] | |
| $2.25 | |
11-61-1-734-684-M17 | Intake Manifold Gasket Intake Manifold to Cylinder Head (1 Per Car), Z3 1.9
Brand: Victor Reinz [More Info] | |
| $4.50 | |
