From: bob@pelicanparts.com on behalf of Bob at Pelican Parts [bob@pelicanparts.com] Sent: Friday, July 16, 1999 2:05 PM To: Wayne at Pelican Parts Cc: d.l.sorensen@worldnet.att.net Subject: Re: 1978-924 turn signals don't work Hi Dave, With the ignition off, and the turn signal lever activated, the signal lamps on that side are designed to stay lighted, but not flash. This is required when parking on-street at night in some European countries. If the turn signal switch and relay are both new (and known to be good), properly installed, and the wiring and fuses are good, I'd next check all the bulbs involved, and make sure that their sockets are clean and free from corrosion. Hope this helps, Bob at Pelican Parts Wayne at Pelican Parts wrote: > Hi there. Let me forward you to Bob in Tech Support, who might be able to > help you out with your problem. > > Thanks, > > Wayne > > > -----Original Message----- > > From: d.l.sorensen@worldnet.att.net > > [mailto:d.l.sorensen@worldnet.att.net] > > Sent: Wednesday, July 14, 1999 6:24 PM > > To: pelicanparts@csi.com > > Subject: 1978-924 turn signals don't work > > > > > > I HAVE A 1978 924, AND HAVE BEEN HAVING PROBLEMS GETTING MY TURN > > SIGNALS TO > > WORK. > > > > THESE ARE THE SYMPTOMS: > > > > 1. WITH THE IGNITION OFF, THE TURN SIGNAL LIGHTS WILL COME ON BUT NOT > > FLASH, THE INDICATOR LIGHT DOES NOT COME ON. > > > > 2. WITH THE IGNITION ON, THE TURN SIGNAL LIGHTS DO NOT COME ON, BUT THE > > INDICATOR LIGHT COMES ON, BUT DOES NOT FLASH. > > > > 3. THE EMERGENCY FLASHERS WORK FINE, ALL LIGHTS COME ON INCLUDING THE > > INDICATOR LIGHT. > > > > I HAVE REPLACED THE TURN SIGNAL FLASHER RELAY, & THE TURN SIGNAL SWITCH > > ALSO. > > > > I HAVE ALSO TRACED OUT AS MUCH OF THE ELECTRICAL & COULD NOT FIND > > ANY OPENS > > OR GROUNDS. > > > > ANY SUGGESTIONS WOULD DEFINITELY BE HELPFUL > > > > THANKS > > > > DAVE S. > > > >