From: bob@pelicanparts.com on behalf of Bob at Pelican Parts [bob@pelicanparts.com] Sent: Friday, June 18, 1999 9:13 PM To: pelicanparts@csi.com Cc: inform@southwest.com.au Subject: Re: Hi there... Hans, About the best we can do is the wiring diagram. Several of the multi-pin plugs on these cars are constructed so that when you take off the cover, all of the pins can fall out of their sockets unless you are very careful. If after looking at the diagram you can't figure it out, maybe you can find an understanding friend with the an SC who will let you peek into his switch and see the layout. Sorry we can't be of more help. Bob at Pelican Parts Wayne at Pelican Parts wrote: > Sorry for the delay in getting back to you. The 911SC wiring diagrams > are on our site if you would like to take a look at them. Other than > that I really don't have any more info. Perhaps Bob in Tech Support can > help you out. > > Thanks, > > Wayne > > 1980 911 in Austraial > Hans Nauendorf > 8 Sandra St Falcon, Western Australia > 6210 > > Australian Mobile number 0414987104 > > I have a small problem. I had to remove the ignition plug from the back > of the switch because the radio shorted out and caused the wire past the > fuse to burn and melt. I needed to replace this and so took out the > ignition switch plug and opened it up to remove the burnt wire. All of > the wires came out at once and so now I have no idea which goes where. > Can you please help with a diagram of which wire goes where inside the > plug. > Hope you can help ... Hans Nauendorf