| BMW Z3 Coupe 3.0i - Intake System - Page 1 |
| From the airbox to the intake manifold, air is routed to the engine at a defined volumetric rate that allows optimum combustion for specific levels of performance. Any alteration or failure within this system can therefore cause drivability problems like hesitation or rough idling. You can try cleaning and sealing these components as much as you want, but more often than not, installing brand new OEM parts is the best cure for these types of problems. |
|
Air Filter |
| It's important to make sure that your air cleaner is clean at all times. The cleaner filters outside air before it enters your engine. Dirty air filters will constrict the air flow, and reduce your overall horsepower and gas mileage. You should replace |
|
| Air Filter, Z3 Coupe 3.0 |
13-72-1-730-946-M67 | Air Filter, Z3 Coupe 3.0
Brand: Mahle Filter [More Info] |  |
| $13.25 |  |
13-72-1-730-946-M63 | | $14.00 | |
13-72-1-730-946-M45 | | $10.25 | |
13-72-1-730-946-M318 | | $50.00 | |
O-Ring |
| Air Cleaner Seal |
13-71-1-720-540-M9 | O-Ring for Air Filter Housing 79 X 6 mm, Z3 3.0i Coupe (1 Per Car)
Brand: Genuine BMW [More Info] | |
| $2.75 | |
| Air Cleaner Mount/Buffer |
13-71-1-259-818-M200 | Rubber Mount Air Filter Housing, Z3 Coupe 3.0i Air Box (1 Per Car)
Brand: MTC [More Info] | |
| $3.00 | |
Air Mass Sensor |
| This meter is part of the fuel injection system and is used to measure the amount of incoming air into the intake manifold. |
|
13-62-7-567-451-M177 | Air Mass Sensor (Hot-Film), Z3 3.0i Coupe
Brand: Siemens [More Info] | |
| $222.25 | |
Engine Air Intake Boot/Hose |
| The Intake Boot is used to connect the intake manifold to the air flow meter. |
|
13-54-1-438-759-M9 | Intake Boot "Tube Elbow" Throttle Housing to Air Boot, Z3 3.0i Coupe
Brand: Genuine BMW [More Info] | |
| $16.50 | |
13-54-1-438-761-M9 | Intake Boot "Tube Elbow" Mass Air Meter to Connecting Ring, Z3 3.0i Coupe
Brand: Genuine BMW [More Info] | |
| $33.00 | |
Intake Manifold Gasket |
| The intake manifold gaskets used to seal the intake manifold to the cylinder head. |
|
11-61-1-440-318-M9 | Air Equilizer for Intake Manifold "Distribution Piece", Z3 3.0i Coupe
Brand: Genuine BMW [More Info] | |
| $66.50 | |
| Engine Intake Manifold Gasket Set |
|
11-61-1-436-631-M17 | Gasket Set for Intake Manifold to Cylinder Head, Z3 Coupe 3.0
Brand: Victor Reinz [More Info] | |
| $26.25 | |
