| BMW X5 3.0i - Intake System - Page 1 |
| From the airbox to the intake manifold, air is routed to the engine at a defined volumetric rate that allows optimum combustion for specific levels of performance. Any alteration or failure within this system can therefore cause drivability problems like hesitation or rough idling. You can try cleaning and sealing these components as much as you want, but more often than not, installing brand new OEM parts is the best cure for these types of problems. |
|
Air Filter |
| It's important to make sure that your air cleaner is clean at all times. The cleaner filters outside air before it enters your engine. Dirty air filters will constrict the air flow, and reduce your overall horsepower and gas mileage. You should replace |
|
| Air Filter, X5 3.0 (1 Per Car) |
13-72-1-702-907-M45 | Air Filter, X5 3.0 (1 Per Car)
Brand: Hengst [More Info] |  |
| $11.50 |  |
13-72-1-702-907-M67 | Air Filter, X5 3.0 (1 Per Car)
Brand: Mahle Filter [More Info] | |
| $14.75 | |
13-72-1-702-907-M63 | | $15.75 | |
Air Filter Housing Clip |
51-47-1-919-209-M9 | Rivet Plastic for Air Ducts, Interior Trim Panels, Engine Air Intake Ducts, X5 3.0
Brand: Genuine BMW [More Info] | |
| $0.75 | |
Air Mass Sensor |
| This meter is part of the fuel injection system and is used to measure the amount of incoming air into the intake manifold. |
|
13-62-7-567-451-M177 | Air Mass Sensor (Hot-Film), X5 3.0i
Brand: Siemens [More Info] | |
| $222.25 | |
Engine Air Intake Boot/Hose |
| The Intake Boot is used to connect the intake manifold to the air flow meter. |
|
13-54-1-440-102-M9 | Intake Boot "Tube Elbow" Throttle Housing to Air Boot, X5 3.0i
Brand: Genuine BMW [More Info] | |
| $20.00 | |
Intake Manifold Gasket |
| The intake manifold gaskets used to seal the intake manifold to the cylinder head. |
|
11-61-1-440-318-M9 | Air Equilizer for Intake Manifold "Distribution Piece", X5 3.0i
Brand: Genuine BMW [More Info] | |
| $66.50 | |
| Engine Intake Manifold Gasket Set |
|
11-61-1-436-631-M17 | Gasket Set for Intake Manifold to Cylinder Head, X5 3.0i
Brand: Victor Reinz [More Info] | |
| $26.25 | |
Intake Manifold Adjusting Unit |
| Adjusting Unit in Intake Manifold, X5 3.0i |
| 11-61-7-544-805-M604 | Adjusting Unit in Intake Manifold, X5 3.0i
Brand: Vaico [More Info] | |
| $205.25 | |
11-61-7-544-805-M9 | Adjusting Unit in Intake Manifold, X5 3.0i
Brand: Genuine BMW [More Info] | |
| $239.75 | |
Throttle Housing |
| On cars with fuel injection, the throttle body is used to control the amount of air entering the engine by means of a throttle cable connected to the accelerator pedal. |
|
13-54-7-502-445-M82 | Throttle Housing Assembly, X5 3.0i
Brand: VDO [More Info] | |
| $271.25 | |
